3rd cycle tren/test/dbol

[volcom stone]

Alright. Next cycle is tren /test/dbol .

My previous cycles have been test/dbol/deca . But it was all QV gear. This is my cycle:

Test cyp wks 1-15 500mg? 625mg? 750mg?
Tren enan wks 2-12 500mg
Dbol wks 1-5 40mg ed

My question is. I have used only QV gear in the past, and never really ran it above 500-600mg range, and I know that the stuff I had was underdosed, others have also said this about QV. This go around will be UG gear that I know is dosed good. Do you think I should go w/ just 500mg weekly or bump it to 750mg? Maybe i'll do 625mg.

Also, would it be ok to do my shots like this.

Monday = Test cyp = 2.2CC

thursday = Tren enan = 2CC

Or do you think I should mix them both? Would it make it less painful if I mixed them? Thankyou

PS I AM SO STOKED ON STARTING THIS CYCLE

[volcom stone]

[houseofpain]

make sure the test is higher than the tren in MG's. shoot every fourth day, and yes mix the substances and shoot them on the same day.

[biggun24]

I personally would run test at least 100mg higher than the tren , but thats just me u may be fine running it like that, maybe some more experienced tren users will chime in.

[JoeB]

By glancing at the dosage of QV gear I do notice that many are underdosed, but by maybe 5mg max. So if you were using 500mg enanth per week, you would be short 10 mg at the most... just something to take into consideration.

Go to the QualityVet web site.. look up batch numbers to see the tested dosage of your gear.

http://www.qualityvet.com.mx/indexeng.htm