Just Did It!

[rixyroids]

hey guys, been 2 mins since i finishd rubbing my injection site of injection number 1 for my 10 week test e (500mg/week) cycle

problem is, when i pulled the needle out, seemed as tho a lot of oil seeped out, inabout half a second b4 i manged to get the alcohol swab to it

any idea what this was and do u think the whole injection was a waste?

thanks bros

[Jtt23]

hey guys, been 2 mins since i finishd rubbing my injection site of injection number 1 for my 10 week test e (500mg/week) cycle

problem is, when i pulled the needle out, seemed as tho a lot of oil seeped out, inabout half a second b4 i manged to get the alcohol swab to it

any idea what this was and do u think the whole injection was a waste?

thanks bros

Just a question... What size pin were you using??

[rixyroids]

23G 1.25 inch

howcome?

[Chookster]

I Use 23g 1.5 In But Have Noticed On Some Occasions It Seeps A Little Oil At 1st Don't Sweat It. Just Make Sure You Inject It All Before You Start Pulling It Out.

[rixyroids]

yeah i musta waited maybe 5 seconds b4 pulling it out, hopefully itl b ok, just have to wait and see rly

any idea on how to stop it??

[almostgone]

Also, look for info on the "Z-track" injection method..it's a little awkward until you get used to it, but it helps minimize the amount that seeps back out..

Take your time injecting also....Good luck

[almostgone]

See if this helps.....
http://forums.anabolicreview.com/sho...rack+injection
http://forums.anabolicreview.com/sho...rack+injection

[bigman1]

No problems bro is this your first cycle? Any ways just place the pad or your finger on the site as you pull the needle out and then press and rub. No oil will seep and you can massage the area to reduce scar tissue. Make sure to rotate your shots. Later bro

[rixyroids]

thanks for the reponses guys, been a gr8 help.

[Jtt23]

23G 1.25 inch

howcome?

Just wanted to make sure that you weren't using something too small.. I have used 1/2 inch 28G in the past.... Just because they were the easiest to carry. (I dont reccommend using them) but i noticed that the smaller the pin, the more "seepage".

[groverman1]

Just leave it in for about 15 seconds after you have injected. Let the oil diperse properly.

[rixyroids]

i will do nxt time, thanks again for the help guys!

[The Shredder]

I find that doing the Z-track method backwards does the trick. It is to hard to do the Z-track method if your injecting yourself. So right after I pull the pin out I pull my skin to the side and nothing ever comes out.

[mule1983]

Welcome To The Dark Side