Terosterona200- Brovel-T-200

Is there any way to sterilize this stuff, Just to make sure.
Thanks for the help.::lift:

:unsure: come on guy's help me out.

if you didn't open the top (i couldn't imagine why you would or how you'd do it) then it should be sterile to begin with. you don't need to worry. just follow sterile injecting procedures.

:help: But I've heard people say they don't trust the company that makes this stuff.

Quote:

---

Originally posted by Chris-mass
:help: But I've heard people say they don't trust the company that makes this stuff.

---

then you should go with a different company if you don't trust them. i've had no bad experiences with their sterility. there's not much you can do about it anyway.

Alot of people talk shit about brovel but tons of people use their products without problems...

I for one will use T200 by TORNEL or BROVEL: )

now for your question about steriling the vials, take a pot with boiling water,take the t200 vial,take a needle and place a hole in the vial with the needle,dont take out the needle leave it their,,,,,,,,,,,, and put it in the pot with the boiling water............ for like 10mins



or you can put it in the oven for 15-20mins at 250degrees ,take the needle place hole in vial,leave needle in the top of the vial,and wait 15-20mins


sterilizing injection,take a alcohol swab the top of the vial (RUBBER PART) and than take another alcohol pad and whipe the injection sites.......

INFECTIONS AND ABSCESSES ARE DUE TO BAD INJECTION PROCEDURE........

I've never had sterility problems neither.

Bro dont believe evreything you hear!

people probably roll in the dirt outside(you never know jerry springer gets his people from somewhere) and come in and take shot or use same syringe but ive usde probably 8 bottles of brovel and 6-8 of tornel over last 2 years with no problems

All the talk of boiling and heating your vials makes me wonder what it does to the test inside. Can the high heat break down the test inside basicaly making it useless? I am not sure.