smallest pin for equ+prop

whats the thinest pin you can use to inject equ and prop in a single shot? thanks

my prop will only fit through a 23g as the smallest. 25g to small.

id imagine eq will fit through anything prop will fit through

25g is possible but difficult and for me, takes a long time to inject, and requires a lot of pressure on the plunger. I much prefer 23g for just about everything.

I have heard of 25g working. I guess it just depends on the brand.

if u run it under warm water a 25g works easy and fast if its loaded with a larger pin

I used 25g

i load a syringe up all 3cc w/ Prop/Eq/Tren and push it threw a 25g Pin every day and works great :D

Ive used 26G X 5/8 in the past, never had a problem.

i hate 25g pins. even with grapeseed oil and 20%bb it is rough to push oil through the little bastards. for me this causes more pain...i loves me some 23's

i about use 25g for everything

I'm trying 25g today, I'll let ya know!

Quote:

---

Originally Posted by sasquatch

25g is possible but difficult and for me, takes a long time to inject, and requires a lot of pressure on the plunger. I much prefer 23g for just about everything.

---

I used a 25g several times... a long time injection = no pain with prop. I take 2 minutes to inject 2.5cc prop/eq or 1cc prop alone and its painless.

use a 25ga and heat your vials in hot water for a minute or so 1st. works for me

Quote:

---

Originally Posted by Fat Mike

I used a 25g several times... a long time injection = no pain with prop. I take 2 minutes to inject 2.5cc prop/eq or 1cc prop alone and its painless.

---

dam 2 min?
takes me like 1.5min for 3cc

PUSH THAT MOFO dood PUSH IT!

i use 25 for prop. it doesn't go in like a 23 but still works. the slower i go the less the prop hurts going in. it takes me on average about 2 minutes to inject 2.5 cc

I use 25ga for everything and no probs. I have some 23ga on hand, for doing suspension or winny, should either one be hard orimpossible to get through the 25er. BTW I draw with a 21ga. Draws up nicely, but doesn't tear up the stopper too badly. 18ga sometimes leaves a hole that won't seal, and sometimes drops little pieces of rubber into the gear.

Quote:

---

Originally Posted by The Baron

I use 25ga for everything and no probs. I have some 23ga on hand, for doing suspension or winny, should either one be hard orimpossible to get through the 25er. BTW I draw with a 21ga. Draws up nicely, but doesn't tear up the stopper too badly. 18ga sometimes leaves a hole that won't seal, and sometimes drops little pieces of rubber into the gear.

---

i had that happen to me also. had to filter it out. i also draw with a 21 gauge and shoot with 25 gauge. is winny and suspension thicker than say deca? i've never used suspension or winny yet. i will though i'm sure.

21 is my fav for drawing only tore up one stopper w/ em and it was a shytty BD stopper :(