05-16-2002, 12:54 PM #1
are 30g darts big enough for Prop
I am gonna be doing bi injections with some prop, is 30g big enough to get the prop thru, I will be drawing with 23g. Thanks guyz. peace
05-16-2002, 01:30 PM #2
No! As a matter of fact a 28g pin has a hard time with water based gear. A 23g is fine for injecting (if you want smaller, 25g is the minimum I would recommend). I use a 23g on glutes, delts, quads, bis and tris.
05-16-2002, 03:17 PM #3AR-Hall of Famer / Retired
- Join Date
- Aug 2001
- Wherever necessary
I dont see how you would get it through - I have heard of someone using 28g but that is the max I think - 25g is hard enough but reasonable
05-16-2002, 03:33 PM #4
it depends on the size of the syringe. if the diameter is very small as is the case w/ 1cc insulin syringes that carry a 30g needle size then it is very possible. in fact oil (prop) will come out of this easier than it will come out of a 23g needle hooked up to a 5cc syringe.
the problem is 30g needles are only 1/2" in length (all the ones i've seen at least).
05-16-2002, 09:52 PM #5
Thanks for the info. Yea i figured if i wanted to go as small as 30g i am gonna have to go with the 1 cc syringes. Yea they are 1/2", bu thats fine cuz I'm doin bi injections. Well at least I think 1/2" is suitable for bi's. Later
05-17-2002, 11:00 AM #6
you´ll be fine with slin darts for the biceps. good luck
05-17-2002, 04:33 PM #7New Member
- Join Date
- Jan 2002
I use slin darts for delt injections quite often it isn't that bad, water based pushes through like nothing but the oil is a bit tougher just take it slow and remember not to push too hard cause you will snap the plunger
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)