Thread: Pin size/injection site?
09-09-2002, 08:06 PM #1
Pin size/injection site?
I'm about to start my 1st cycle and I'm not sure what I should get for pins. Size legnth/G, quantity, etc.
Also I'm not sure about injection sites. If I'm injecting 2x a week should I be injecting in other places than the glutes? Here's the cycle I will be doing:
Week 1-11 400mg/wk test Enathate
Week 1-10 400mg/wk EQ
Week 1-4 40mg dbol
.25mg/ day armidex
Novadex on had as welll as Clomid.
Thanks for any help guys.
09-09-2002, 08:14 PM #2
i use 23 gauge 1 inch for my glutes.twicw a week is not bad at all ,u can rotate sites delt delt glute glute,as long as ur not hitting the same place more then twicw a week u should be fine .
09-09-2002, 08:17 PM #3
You can inject lots of places.
If your b/f is alittle bit high i would say go w/ a 23 g inch and a half pin for the glue. If not go w/ a inch pin.
It's easier to draw w/ a smaller g needle like a 20 g. But then you have to switch pins before u shoot.
I personally only use a 23 g inch and a half for everything. Just don't stick it in all the way if your injecting into you shoulder etc.
Also you can mix the Enth & Eq in the same shot
Go here if you wanna see where u can inject.
09-09-2002, 08:17 PM #4
1 inch is good for anywhere. 1 1/2 is good for the glutes, too
09-10-2002, 05:41 AM #5
Thanks guys, I'm thinking 23gauge 1 Inch and to rotate between the glutes and delts. Is a 3cc syringe enough? or should I go bigger?
09-10-2002, 05:45 AM #6
3cc's is fine. You really don't want to put any more than 3cc's into one site at a time.
09-10-2002, 06:38 AM #7
i really think 1.5 is best for glutes. everything else is good for 1" its a large group and can handle it. that way your not worried about getting far enough into the muscle.
09-10-2002, 07:03 AM #8
- Join Date
- Aug 2002
- Blog Entries
What if all I have are 1.5" pinz and I wanted to inject somewhere besides glutes. Could I just not stick the pin all the way in?
09-10-2002, 07:39 AM #9
you sure can, most of the time in my calves i dont stick all 1" in. i may go 5/8ths or so.
just stick it in how far you need and dont touch the needle with your fingers. you will be just fine.
09-10-2002, 10:06 AM #10
General rule of thumb for length, regardless of the needle's gauge: 1" for delts and quads, 1-1/2" for glutes (because the glutes have more fatty tissue to go through until you get into the muscle).
(Keep in mind, however, that most 1-1/2" pins are 22 gauge, which is a bit thick to do a quad shot comfortably. Nonetheless, you can use the length anywhere, providing you stick to the above guideline on how far to stick the needle in. I would be wary of using 5/8" needles, since you want to go intramuscular - into deep muscle, regardless of where you inject.)
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)