blood in syringe

I drew back to see if there was any blood and didnt see any so I went ahead and injected, but after I finished I noticed there was a little blood in there, is that going to create problems or am I cool?

WHOOAAA you pulled back and didnt see any but then shot in and suddenly showed up with blood? doesnt quite make sense.....

Did you just do this, or has it been awhile? You should be all right bro. You not of aspirated when you thought you did...give it a sec and keep breathing then depress the plunger when you're sure there isn't any blood flow.

You should be fine.

Aragorn

i have seen that happen too actually, sometimes you can aspirate and nothing happens but then you see blood droplets in the syringe at the end

I had it happen to me. I aspirated then injected then when i pulled out saw some blood in the needle. I think i just went through a vein and it got in the needle on the way out, cause i know i bleed alot as well. As long as you feel fine its all good.

It just happened to me about an hour ago. I just figured that I went through a vein and on the way out got a little back into the pin. It does kinda hurt a bit now, but not too bad.

I feel fine just more sore than usual

Its fine bro. U probably just went threw some scar tissue. No worries happens to me sometimes.

OG

its possible you went through the vein enough to asperate clean.

then as you finished your push, you might have pulled out just enough that a bit was sucked up into the syringe.

I have had that happen once, but didnt cause any problems.

Same exact thing happened to me the other day...I aspirated and everything...after I was done there was a little blood left in the end of the syringe. I'm still alive bro, don't sweat it.