Allright....i gotta ask...

Guys, if there is a thread pertaining to this, please don't flame me and just point the way....I searched but didn't really find an answer....

Why the hell does it take me so long to draw out my gear? I am using 25g to draw out the EQ and Test and it must take about 10 minutes to get it all in the syringe.....is it because I am using the 25g to draw? Here is how I draw. I tip the jug upside down, inject 1cc of air into the gear then stick the tip of the pin into the gear and start drawing....

If this is just normal let me know as I feel I am doing something wrong...

Thanks bros!

yep, eq and test are thick oil based products, try getting an 18g, 22g, 23g, etc to draw with, and then if you insist on shooting with 25g just switch over, i draw with a 22 and shoot with a 23, but drawing with an 18 for oil based takes like 2 seconds, its great...good luck

25g to draw. that is a good pratical joke. hehe...

get an 18g or 20g. even a 20g is noticeably slower than an 18g

Lewd

I draw all my AS with an 18g and then switch it to a 23g 1" pin to inject...this makes it easier to draw as well as it doesn't damage the 23g pin for injection

All I use is 18's for drawing. Any higher and it takes too long, any lower and the needle is so big, it shaves rubber from the top of the vial into your gear.

Thanks guys.....I do switch over to a 23g to shoot with, but when I picked up the pins at the CVS here the only size they had was 25....I will go pick up something bigger as soon as I can....Let me ask one more question>>>Is the 25g cool for the water based winny? I have a bunch and don't want to throw them away if I don't have too.

The needle is going to clog if u try to shoot winny thru a 25 gauge.
I would stick w/ the 22 or 23 gauge for injecting winny.

i shot winney thru a 25 gauge pin, no problem, never had any problems with cloging.

Hey bro i use a 22g 1.5' pin to draw and it takes me about 30 seconds to get it all out.

OG

Quote:

---

Originally posted by OGPackin
Hey bro i use a 22g 1.5' pin to draw and it takes me about 30 seconds to get it all out.

OG

---

ditto here .. Also, I inject 2cc's of air into the vial instead of 1. You'd be surprised at how much of a difference that extra cc of air helps. Like the other Bro's said though, 25G is just too small for drawing.

9

THANKS BROS.....

is it a bad idea to use the same needle that you use to draw, to inject with too??
im planning on using a 22g to draw and inject sust 250

Susspitbull, It is not recommended, to inject with the same pin as you extract with, in vials. Now you mentioned sustanon, I used to and still do sometimes draw and stick with the same pin, if I am taking my sustanon out of an amp. As long as you don't damage the point in an amp, I don't see why not.

I use 18g to draw Sus then 22g 1" to inject in quads. Procedure takes no longer than 3 or 4 minutes. I think 25g is to small to inject winny. I would use at least 23g if not 22. THere is really no pain difference with either one. I once saw a guy at the gym who broke off a 25g pin in his leg because of the winny clogging it up. just my 2 cents, later bro.

Try running hot water over the bottle or vial to heat up the oil. It will become thinner, and flow easier.