im about to do my 1st shot but i cant get all the bubbles out...theres 2-3 tiny bubbles struck to the side of the syringe...i tried flickin it but it wont go to the top...am i worried about nothing?
Printable View
im about to do my 1st shot but i cant get all the bubbles out...theres 2-3 tiny bubbles struck to the side of the syringe...i tried flickin it but it wont go to the top...am i worried about nothing?
when you aspirate the bubbles at the top should suck back in to the muscle.
you did aspirate, didn't u?
if u just drew but there are bubbles, depress the plunger until some gear runs down teh side of the pin to lube it. that will eliminate any air before aspiration.
other than that, no problem injecting some small bubbles into a muscle bro, completely safe as opposed to injecting bubbles into a vein.
hope this helps.
if there very small then no worries as long as you not ijecting like a cc of air into you. The few tiny bubbles wont hurt.
Next time try heating you oil up under some hot water while it is in the amp/vial and the thinning of the oil sometimes helps with those bubble issues.
i pushed most of the air out and some juice leaked down the needle but there are still 2 or so bubbles one stuck on the side and 1 at the top they wont come out...u say jus to make sure to aspirate and it wont b a prob?
thanks
Hey bro, no worries! Stick away... ;) A few little ones wont do anything.
OG
THANKS ALL here i go
just did it but i 4got to aspirate!!!...everything went ok it seems but i forgot that I CANT believe it....im ok tho aslong as i dont pass out rite?
relax bro you will be all set. maybe the bubbles will make your nuts come back faster!LOL
You'll be fine bro. Just don't forget next time. Take your time and slow down. No need to rush it and forget something, like aspirating!
-moto
how did you forget to aspirate when my post was a clear reminder as i mentioned it 3 different times? lol