Serious pain after injecting Omnadren..

I have been injecting Omnadren for a few weeks into my buttocks and it always gives me a little soreness but on last monday i injected 1cc into my right thigh with a 23gauge 1 1/4" needle and yesterday i was having some serious pain.. I was not able to use my right leg and still to day i barely can walk and it hurts like hell.. I have had this problen once before with omnadren on my last cycle and that was when i injected in my buttock... This is really serious problem for me because I can´t go to work like this, it´s very hard for me to walk... Is there anything I can do to get by this? Has anyone had the same problem?

I´ve been thinkin and i think I have maybe went trough the muscle? In both cases I injected where the muscle is very thin... What happens if you inject into something other than muscle?

anyone?

for startes.. congraulations your gear is 100% real.. When i do sust or oma's I love it when it hurts cause then you know its real.. As for easing the pain? message the area hard for 5 mins after injecting.. and i think ice would help over the next few days.. and by the way you want to inject into THICK muscle not thin.. so check out siteinjection.com i think thats the site?? you can learn to inject properly here

Try running the syringe under hot water for a few seconds to thin out the oil. Then masage the site for a while afterwards. This will help the solution disperse and that means less pain.

xxxl83

Thx for the answers... Well I know it´s supposed to hurt because i have done it before but i was just wondering if maybe I stuck the needle trough the muscle... Is that possible? The area where I injected is very thin. I know I should have been more careful and all that, but the damage is done and it hurts like hell, today is the first day I can walk since monday. What do U mean when U tell me to heat the syringe? Should I heat it before or after the oil is in?

Quote:

---

Originally Posted by Frozenone

Thx for the answers... Well I know it´s supposed to hurt because i have done it before but i was just wondering if maybe I stuck the needle trough the muscle... Is that possible? The area where I injected is very thin. I know I should have been more careful and all that, but the damage is done and it hurts like hell, today is the first day I can walk since monday. What do U mean when U tell me to heat the syringe? Should I heat it before or after the oil is in?

---

heat it with the oil in it and u can also cut the amnda with some sterile oil to make the pain less.

Warm compresses to disperse the oil. Ibuprofin for inflammation and pain.

I´m going to try that next time...

Thanks for good answers!

Perhaps a better technique for heating the oil would be to heat it while it is still in the vial or amp. this is because glass is a better conductor for heat than plastic, and may do the trick better.

I've only shot once, so I'm less experienced than even you, but here's what I did on my first time and I believe it worked well:

take a bowl or mug and fill it with really hot water (not boiling, but as hot as your faucet will allow). Only fill the mug/bowl high enough so that the vial is not completely submerged, but that it is to its "neck" where the rubber stopper is; leave for about 3 minutes. If it is an amp, then I suppose you can submerge the entire thing.

That's it! lightly shake the vial (like in a circular motion) so that the oil stirs around a bit so the oil in the center extracts some of the heat from the inside vial walls.

good god I just noticed how old this thread is!!

:lol:

dude could be dead by now from a lethal inj for all we know.