Taking an injection and some oil runs out? Especially in my delts... I'll take a shot of sustanon and sometimes some of the oil starts running... anyone else ever have this happen :unsure:
Printable View
Taking an injection and some oil runs out? Especially in my delts... I'll take a shot of sustanon and sometimes some of the oil starts running... anyone else ever have this happen :unsure:
what gauge syringe are you using?
Happens to me on glutes and delts. Not very much gear to worry about.
21 and a half in my delt and tri's... 22 in my glute... I think i'm going to have to start using the bigger gauge in my delt and saves the 21.5's for the triceps only
Yes this happens to me occasionally.
In order to minimize the bleeding and the amount of AS that leaks out, you can use the Z-track method described in the following link (nursing student's guide to intramuscular injections):
http://www.breastcancerprofessional....nc/nursing.pdf
(Summary: pull the skin of the area to be pierced to one side before you inject. After you pull out the needle, the skin will fall back in place, blocking the hole left by the needle and minimizing bleeding/leaking.)
Are you putting pressure down on the site afterwards- it helps.Quote:
Originally Posted by GeoQuadzilla
Good info Bask8kace.
You know what?..... That's a great idea... I'm gonna try it tommorrow... since im on the topic should i stick an extra cc of sustanon at the end of the week just incase... because my last two delt injections done that to me with the leaking? I'm running 750mg's of sust, and 400mg's of deca... the only place i ever get any leaking is in my shoulders... good idea? :unsure:Quote:
Originally Posted by BASK8KACE
Yep and i also massauge it... I find my blood really thin when i'm on cycle... whenever i bleed from a shot or even anything like a small cut it bleeds more then it should.Quote:
Originally Posted by bmg
Quote:
Originally Posted by GeoQuadzilla
21.5ga in the Delts and Tri's? Holy Chit.... I've never seen a .5 ga needle b4.
I use 25G for everything except the glute where I use 22Ga.
Have you ever used 1 inch to the glute.Quote:
Originally Posted by MachZ
The little amount that leaked out of your shoulder is not going to affect your cycle. Just run your cycle as you normally would. You're already running 750mg per week; an extra cc would be overkill.Quote:
Originally Posted by GeoQuadzilla
Good enough man... Thanks for the info :lift:Quote:
Originally Posted by BASK8KACE
I have used both 1" and 1-1/2" for glute. I would go with a 25Ga for glutes but doing my own glute shots are kinda awkward so I want to be done as quick as possible.Quote:
Originally Posted by bmg
Thats an oil pipe 21.5 in the delt. 25 everywhere but the glute 22ga get it over with.
Never had a problem til recently... but like i said... i'll have to use the 22 gauge... it's no biggie :lol:Quote:
Originally Posted by cpt steele
happened to me once on my quads. Test prop, and a little bit of blood came out.
Quote:
Originally Posted by cpt steele
**** 21's are a ****in hose, all gear should run through a 25 smoothly, if not just heat it up under the faucet and there should be no problem.
K boys misprint here... my needle i use in my delt is 22gauge and the needle i use in my glute is 22 and a half so i printed wrong... the 22 gauges cause the oil run off in the delt! Sorry for the misprint :(
happens to me in the delts. put a CLEAN finger over the hole and press firmly for a minute. massage and you'll be good to go.
I actually learned that method form this board. Some one asked the same frikkin question a while ago. The tip works great.