Thread: heat the oil (test enth) in amps
-
02-19-2004, 04:17 AM #1Senior Member
- Join Date
- Dec 2003
- Posts
- 1,356
heat the oil (test enth) in amps or syringe?
how do you heat the oil for easier injections?
i was thinkin that maybe is better to heat the oil in the syringe (ready to be used) coz if i heat directly the amp, before i open the amp, i draw the oil and i get ready to inject it will go back to normal temperature...
what do you think?
if i heat the loaded syringe under hot water, will it be safe for the needles (should i leave the cap on it).
thanksLast edited by fabry; 02-19-2004 at 04:56 AM.
-
02-19-2004, 05:14 AM #2Senior Member
- Join Date
- Dec 2003
- Posts
- 1,356
c'mon guys!!!
-
02-19-2004, 05:27 AM #3
Hi Bro
I always heat the amp in a cup of hot water. If you drawing it out with a 18g needle it only takes a sec. It all depends on what enanthante you have. my friend heats his up in the syringe with the draw needle and then puts a 23g 1inch pin for his injection. that way if you get water on the needle it's only on the draw pin not the one your injecting with.
peace
-
02-19-2004, 05:36 AM #4Senior Member
- Join Date
- Dec 2003
- Posts
- 1,356
good boy, great advices! just needed to "use my brain" a little bit more...
my test is iranian test enanthate ...
-
02-19-2004, 07:28 AM #5New Member
- Join Date
- Feb 2004
- Location
- INDIANA
- Posts
- 10
I run it under hot water in the syringe for about 1 1/2 min for 3 cc's
-
02-19-2004, 07:32 AM #6Senior Member
- Join Date
- Dec 2003
- Posts
- 1,356
i think ill just draw into the syringe, heat it under water with the drawing needle and then change this one right before injecting.
thanks
-
02-19-2004, 07:34 AM #7Junior Member
- Join Date
- Sep 2003
- Location
- in your head
- Posts
- 120
I didn't know you had to heat it also why would you is it thick? just curious bro
-
02-19-2004, 08:08 AM #8Senior Member
- Join Date
- Dec 2003
- Posts
- 1,356
i think is just a scientific trick... if you heat a oil, it becomes more fluid and easier to inject.
not necessary...
-
02-19-2004, 08:16 AM #9
yes, heating it thins the oil out. i usually run my amps of testoviron under hot water for less than a minute until when i shake it around it looks really watery, then draw and inject.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
SVT and steroids?
Yesterday, 09:28 PM in ANABOLIC STEROIDS - QUESTIONS & ANSWERS