worthless synovex?

[1badcamaro]

ok, my buddy and i successfully made our first batch of synovex with no problems, it came out perfect. We made the other one last night and all was going fine until we took the powder out of the oven, the power has become glazed and is in chunks.........what happened, i mean we set the oven at 250 degrees, could the oven have been off that much to do this...........is it now worthless?

[motoxxxguy]

It just melted. Break it up and proceed as normal. You should be fine as long as the test isn't burned.

BTW, this isn't the lab forum!

-moto

[1badcamaro]

really sorry about the forum, how do i tell if it's burned though, like if its blackened?

[ColdSore]

dude do you not have access to prop powder?

powder sources are alot harder to come by, so i would say probly not...syno has to be a pain in the a$$ to make

[DF2003]

yea thats why i deleted i didnt want to sound like an azz.

[DF2003]

thats what im sayin. i mean it may be simple to make but **** why not just buy some prop final product?

powder sources are alot harder to come by, so i would say probly not...syno has to be a pain in the a$$ to make

[ColdSore]

thats what im sayin. i mean it may be simple to make but **** why not just buy some prop final product?

well it would be alot cheaper...i pay $35 bucks for 10ml's 100mg/ml vial...so for 10 weeks it would run me $245 bucks...

but on the other hand i get powder of .60 cents a gram, plus oil, ba, bb, vials, and filters and i can make it for about 5 bucks or less...syno would be a little more but still alot cheaper then buying pre-made...

see what im gettin at?

[DF2003]

those powder prices seem very familiar....hmmmm.lol

well it would be alot cheaper...i pay $35 bucks for 10ml's 100mg/ml vial...so for 10 weeks it would run me $245 bucks...

but on the other hand i get powder of .60 cents a gram, plus oil, ba, bb, vials, and filters and i can make it for about 5 bucks or less...syno would be a little more but still alot cheaper then buying pre-made...

see what im gettin at?

[ColdSore]

those powder prices seem very familiar....hmmmm.lol

maybe so???

[1badcamaro]

I think coldstone summed it up when he said how much cheaper it was, that is why we went with the homebrew instead of the final product. My test came out fine, i just don't know why my buddies melted, well moto says its all good so i guess we'll proceed and maybe try to find a place to have it tested.......any suggestions with that?

[bigbouncinballs]

i know of a great testing place... in my ass.
just send it on over, i'll let ya know!

[asiancuts]

why not just let the crystals air dry overnight instead of putting them in the oven and risking a mess up?

[1badcamaro]

We put them in the oven cause its our first time and we were just following precise instructions, maybe next time we'll try that but yea i guess my buddy will just have to try it for a few weeks and see if hes gettin results........thanx guys

[Antwan]

The melting point for it is 248 according to Da**** site. So if you had the oven at 250 and its probably off some, its no wonder it melted. I just made some myself for the first time too.