PDA

View Full Version : Newbie Vial Question


Ammar
04-12-2003, 12:05 AM
For those single vial steroids, how do you break the vial so you can put the needle in there?

Trevor
04-12-2003, 12:08 AM
Get a fingernail file and file around the top just a little bit. Then get the lid off of a bic ink pen and put the ink pen lid over the top of the vial and just snap it off in a smooth quick motion.
Good luck
Trevor

Ammar
04-12-2003, 12:48 AM
Is it possible to just use some sort of pliers and just cut it that way?

fast
04-12-2003, 01:17 AM
Ammar: It`s not a stupid question, you just putted it to wrong place. Put it under "Steroid Questions".

Ammar
04-12-2003, 01:17 PM
OK my bad guys...but can I just use pliers to cut the top open or is that unsafe and unsterile?

Sicilian30
04-12-2003, 03:00 PM
Amp opener works beautifully.

Ammar
04-12-2003, 03:14 PM
where can I find an amp opener?

blastin-enth
05-06-2003, 02:34 PM
"Get a fingernail file and file around the top just a little bit. Then get the lid off of a bic ink pen and put the ink pen lid over the top of the vial and just snap it off in a smooth quick motion.
Good luck
Trevor"

This is the best and safest way. pliers will most likle breake the whole ambule in your hands ....

BIG-G
05-06-2003, 02:47 PM
get****.com or researchkits have amp openers for you !

aanold
05-09-2003, 02:11 PM
Originally posted by Ammar

For those single vial steroids, how do you break the vial so you can put the needle in there?

Ammar,

Were you talking about a small vial or a glass ampule, cause I noticed later you also mention using pliers?

Cause if so you would just need to remove a section on the top to expose the rubber stopper. You would end up swabbing the rubber stopper with an alcohol swab to make it sterile before pushing your pin through.