Printable View
I have serostim 6mg vials, the bottom looks like little round coins of powder, i reconsituted it and it has bubbles and its alil cloudy in the syringe, the first vial i made was fine, only added 1cc of bw, second one was cloudy added 2cc's of bw any thought on why??? is it good???? i refrigerated it as usual after making it
someone has to know this
is it supposed to have so many bubbles after adding 2cc's, i never shake it usually let it sit and swirl it alittle
i don't know what it is but it has nothing to do with the amount of water you added.
-rodge
is it bad to have bubbles, first vial was ok
swirl it gently to mix the lyphosized power, and let it settle the bubbles will go away. Did you inject the water directly at the powder or along the side of the vial as you are supposed too?
right on the powder, slowly though, how do i inject water on the sides
Try do angle the needle toward the side of the vile while holding back on the plunger. When you introduce the needle into the vial, the suction will take the BW out of the plunger immediatley. This may take a few times to master. After BW is added, gently swirl contents around in a circular motion. As far as the bubbles afterwards your fine. Let them settle before you administer your shot.
i hope you are not re-using the needles. but you can actually bend it further so its almost agains the side of the vial.
the swirling is not really much technique. I used to just slowly turn the vial on its bottom edge and rotate it.