Drawing IGF Question!

Whatsup guys.

Have a mg of IGF. Drew in the BW first, then the IGF, but the IGF that I drew in sank to the bottom of the BW, so when I inverted the slinpin, it was closest to the plunger. Since it's such a small amount, I wanted to make sure to get it all into me, but I'm skeptical.

Has this happened to anyone else?

Any suggestions?

Thanks bros.

To solve your issue with getting every last micro grain of LR3 in your muscle.After you have both the LR3 and BW in the pin.Point the pin towards the ceiling and draw in 20 mcgs of air.Reverse the pin pointing towards the floor and tap the barrel to get the air bubble right against the plunger.Then fire away.The air bubble will push any liquid left over out of the syringe.
Don't worry.20 mcgs of air in your muscle will not harm you.

I do the same exact thing Pinnacle advised you to do. The only difference is that I dont draw up any BW. I just draw up my LR3 then use the "bubble method" and inject, I dont see any reason to mix it with BW.

thanks a lot guys, appreciate it very much. ill give it a shot and update ya. thanks bros.