Thread: My first picture post
12-27-2002, 09:24 AM #1
My first picture post
I am most of the way done my cycle.... ran EQ at 400mg/week 1-10, but will probably come up 2 weeks short... and have been running fina at 75mg/ed for 4 weeks now......
hope the pictures come in.... the first is before i started the cycle at 198 lb. and about 9.5% bf
12-27-2002, 09:27 AM #2
lookin far more thicker, traps look fuller, chest looks fuller, arms look a-bit bigger
where's the wheels??????
12-27-2002, 09:27 AM #3
OK cool it worked.... here are the two after shots so far.... any feedback would be appreciated.... I am about 205 lb. maybe slightly less bf%... i have about a week left with the EQ, and 2-3 with the Fina....
With EQ and Fina, I shouldnt lose too much ? I think i will run fina again at the beginning of the summer, either alone, or with some winny....
12-27-2002, 09:28 AM #4
lol... those first two are both before.... sorry, its kinda confusing... i was just flexing in the pic on the right.... the two below are the after shots....
12-27-2002, 09:36 AM #5
Just don't cut too much more or you will have to buy some new drawers LOL Those are about to fall off.
Looking nice and lean. Good job.
12-27-2002, 10:16 AM #6
Very well done..
You can see you leaned out a bit....not bad at all...
12-27-2002, 11:14 AM #7
I take it this is a cutting not bulking cycle?
12-27-2002, 11:18 AM #8
i wasnt really approaching it one way or the other..... I guess it was a lean mass cycle.... I was looking to add some size, nothing significant, but only lean muscle... with no fat or water.....
my weight went from 198 to about 204.... so that is 6lb, but i think i have lost a little fat as well, so i have actually put on more than 6lb of muscle.... and i still have a few weeks to go....
i will probably run fina alone again in the early summer to try and get to about 210 and 7%.... for now, i will increase the cardio, and change my lifting to try and cut back on the time spent on weights.....
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)