The Real Secrets of Bodybuilding
Yes I no its long but ant you interested in widening your knowledge,yes good then read it. I highlighted in red, some interesting pointers....
Good read, full of tips for new members.......have a look..
The Real Secrets of Bodybuilding, by Mark S. “Poppa” Lewis
The real secrets of bodybuilding are probably already common knowledge to a large number of trainees. Most people who are privy to these "secrets" fail to regard this information as able to play a key role in their bodybuilding endeavors. In fact, they may not even incorporate many of these principles at all. In this article I point out that enhancing the shape of a given muscle not only makes for better body proportions, but will also give the illusion of greater size.
I'II bet the title of this article raised a few excited hairs on the back of your neck. You have no doubt read a number of times that there are no secrets to building a superior physique - just hard, persistent training, plenty of good food and supplements, enough rest, and a dash of genetics. After all, if there were some secrets, certainly someone would have let the cat out of the bag by now!
Well, boys and girls, its time that somebody enlightened you. You may already know some of what you are about to read, but chances are that even if you do, you've been ignoring it.
Looking at any mechanical device does not usually give the slightest clue as to how it works or how it is put together. However, if you were to tear it down, piece-by-piece, you would no doubt wind up with a much better understanding of how it goes together as well as how it works.
This principle works the same way with nearly everything in life. If you find yourself in a money jam or with a romantic problem, a systematic teardown will help you to see just what is what. Then you'll have a much better chance of putting things back together correctly. This theory also works very well when it comes to bodybuilding; so let's tear bodybuilding down into its component parts.
The first factor that comes up will obviously be size. Oh, yes, mass is still king! Then you have shape, proportion, symmetry, hardness and vascularity. Most other terms are simply synonyms for these terms or varying degrees of them. (For a very good breakdown of all of the popular descriptive terms in bodybuilding, pick up a copy of Sliced by Negrita Jayde and the late Bill Reynolds.)
Most of the terms used to describe a physique pertain to contest condition. I'd like to deal here only with the essentials of bodybuilding - namely, critical mass, general muscle shape and proportion. These three factors are very closely related since shape and proportion greatly enhance the illusion of size.
To illustrate this fact, it is probably safe to say that you have seen lots of different bodybuilders, both amateurs and pros, pictured in the magazines. If you have ever had occasion to see one of these same athletes up close and in person, you doubtless noted one of two circumstances. The athlete in question was either bigger than you had thought or not as big as you had expected. That is because when you see them up close, you can assess their proportions more accurately relating to their surroundings. Lee Haney is very big in person, while Steve Brisbois is surprisingly small. But Steve's shape and proportion make him look huge! (He also happens to have one of the best-proportioned and most complete physiques in the world.)
Now, one matter I feel needs to be cleared up before we go on is the difference between proportion and symmetry. Most people think that these two terms are interchangeable, but they, in fact, have very different meanings. Proportion is the size and shape of one body part relative to other body parts. Symmetry, however, refers to the balance of these proportions to the corresponding proportions on the opposite side of the body. In other words, if you were to divide the body down the middle and fold it over onto itself, the sides should match perfectly. Good luck! Nobody - but nobody - has perfect symmetry. Check out a photo of Arnold doing a front double biceps pose. One biceps is long and full, while the other is shorter and has a peak not unlike the Rock of Gibraltar. Some people have very good symmetry; others do not. (Look a little closer at the pictures in this magazine. You'll see what I mean.) This phenomenon is largely due to genetics and deserves another article. With that out of the way, let's get into size, shape and proportion.
When it comes right down to it, most of you know the basics of building size. But size alone does not make for a winning physique. The real secret is to create the look of greater size by building shape and proportion. (OK, so that much you've heard before.) There are, unfortunately, many well-muscled people who have no flow to their physiques -just a bunch of big muscles thrown together onto a frame with no visual relationship to one another. This is the type of body that, if the individual body parts were to be photographed and shown to you, you'd think they belonged to several different people. This doesn't make for a very pleasing look. The body parts should flow together harmoniously.
Starting at the bottom and working our way up, let's tear the body down into some of its component parts and find out just how size can be enhanced through training for these two qualities of shape and proportion.
The calves are notorious for being difficult to build. Even with the worst genetics in the world there are a couple of tricks you can employ to get the most out of your lower-leg development.
First, to pack the most size on your calves, concentrate on seated calf raises instead of standing calf raises. How many people do you know who do seemingly endless sets on the standing calf machine and have little or nothing to show for it? Since the seated calf raise puts most of the emphasis on the soleus muscle, the largest muscle in the lower leg, doesn't it make sense to rely on this exercise for size? So, for pure calf size, start a very close relationship with every seated calf machine you have access to! Use the standing calf machine (and any other calf movement in which the knees are kept straight) to enhance that size and to carve in the diamond shape by bringing out the two heads of the
underlying gastrocnemius muscle.
Personally, I think donkey calf raises are better than standing calf raises for building the gastrocs. Because of the way the gastrocs tie in with the hamstrings at the back of the leg, the bent-over position of this exercise offers an advantage over other straight-leg calf movements.
Another tip for better calves is to work the anterior tibialis on the front of the shin. This adds a tremendous plus to the overall lower-leg shape as well as making the calves appear larger from the front and the side. (I covered tib work in a previous article.)
Moving up the leg, let's talk about the thighs - more specifically, the quadriceps. My apologies to Vince Gironda and others, but I'm one of these guys who strongly believe that the squat is the granddaddy of all exercises. I do agree, however, that, misused, they can strain your lower back, butcher your knees, spread your hips, build a big butt, and ruin your proportions. (Notice it is your proportions that can suffer, not your symmetry, as both hips will appear to spread and both sides of your butt will be stimulated into too much growth.) The key here is to execute the exercise correctly. If you do, the results will be more than favorable while at the same time avoiding all of the aforementioned problems. To start with, keep the bar just above mid-traps and the back flat unto itself and as nearly parallel to the wall as possible. There will naturally be a degree of forward lean, but keep it minimal. Don't look at the ceiling, as that will force you to arch the back, causing low-back strain. Also, no matter how wide your foot placement, turn your toes out just a bit and make sure that your knees travel out directly over the toes. Any lateral movement of the knees plays hell with those joints. And don't bounce at the bottom of the rep. (Again, good-bye healthy knees!) In fact, you want to almost start to push up before you are in the bottom position. Finally, don't make the classic mistake of raising the butt first. Imagine that there is a string coming out the top of your head, and that you are being pulled straight up by that string. Always lead with the head. If you adhere to these basics, squats can serve as the core of your size-building routine without adversely affecting shape and proportion, and without causing any nagging injuries. If you prefer parallel squats, that's fine. I've always preferred full, rock-bottom squats, and have suffered none of the typical squatting problems in nearly twenty years of squatting.
Around to the back of the thigh, our next subject is the hamstrings. It seems the large majority of bodybuilders have sub-par hamstring development. Everyone does the standard leg curls and the standard stiff-Leg dead lift. Leg curls are great, but the standard stiff-leg dead lift leaves something to be desired. Recently you have probably read about John Parrillo's style of executing this exercise. Well, this guy is right on the money. I've done this movement - now known as the "Parrillo dead lift" - for years. I always just had my trainees list them in their training logs as "stiff-leg dead lift: short rep." As you stand erect with the weight at arms' length, jut your butt out to the rear, arch your back and bend over, keeping your face flat to the mirror or wall in front of you. Picture yourself bending at the hip joints more than at the waist. Keep your back arched and your face up throughout the movement. You'll only be able to get the bar down to about mid-shin level at most, but boy, will your hamstrings get a workout! This style is much better for the lower back, too. Naturally, better hamstring development will add size to the thighs, make your physique more in proportion with itself, and give it a more complete look all the way around.
I like to view the midsection as more than just abs and obliques, so we will include the lower back in our midsection discussion. The first secret to a small, tight midsection is don't use much (if any) resistance in your exercises. The only area of the midsection that really needs extra resistance, other than bodyweight, is the spinal erectors of the lower back. If you use weight in abdominal exercises, you build muscle. (That makes sense!) A little muscle goes a long way as far as abs and obliques are concerned. You don't want to ruin your proportions with a thick waist, even if the thickness is muscle. This is all too easy to do, and unfortunately, many trainees have done it. Remember, the smaller the waist is, the bigger everything else will appear. You want your midsection to be tight and tapered. Besides, your abs get worked with resistance in nearly every exercise you do in the gym since they are needed to stabilize the body to some degree in just about every position. Proper diet is the key to making those abs show. (Yep, that's another article too.)
The abdominal crunch is without a doubt the most efficient ab exercise there is, and it works the entire abdominal wall, not just the upper abs. At my gym, The Dungeon, we do what we call "football crunches." This movement utilizes a small football - actually it's a squeaky dog toy - placed under the chin while crunching, to keep the movement strict. Just lie on your back on the floor with your feet elevated. Your thighs should point up to the ceiling but be angled ever so slightly away from the torso, and your calves should be parallel with the floor. Do not, however, rest the lower legs across a bench. Once the exercise gets difficult, you'll tend to push on the bench with your legs, bringing the hip flexors into play and taking tension away from the abs. Cross your arms across the chest or lightly rest your fingers on your abs to feel them contract. Now crunch up to a position where your shoulder blades are off the floor. This is the starting position of the crunch. From this starting position tension will remain on the abdominal muscles throughout the entire set, and that's just what we want. Now, from this "half-crunch" position, pull the torso towards the pelvis as far as possible. If the football under your chin squeaks, you used your neck and traps for momentum by throwing your head forward, and that repetition doesn't count towards the number of reps in the set. If the football falls from its place under the chin as you return to the starting position, you went too far down too fast and undoubtedly arched your lower back. This is another indication of cheating, and that rep doesn't count toward your repetition goal either. Everyone seems to enjoy crunches done in this fashion. In fact, that little squeaky toy sometimes causes quite a bit of laughter. If you don't have a squeaky toy, perform your crunches in the manner described, taking special care not to flex the neck during the movement. Do this by ensuring that there is always room for three fingers between the top of your chest by your collarbone and your chin. Closing that gap any tighter indicates cheating and a less effective exercise.
It's probably a good idea not to use the various forms of leg raises to hit the lower abs, because of the fact that most of the work is actually done by the hip flexors that originate on the upper leg bone and cross through the pelvis, inserting to the lower back. Too much hip flexor work can create strength imbalances, strain the lower back, and actually weaken the abs. If your diet is good, and you do your crunches correctly, specific lower-ab work may not even be necessary. If, however, you feel the need to work the lowers more directly, reverse crunches are good.
