rubber pieces break into vial

**Liftnainez** · 11-15-2005, 07:31 PM

sup fellas.. my freind ordered a UGL Test and part of the rubber stopper is in the actual vial.. when i say part its a VERY SMALL spec but can be seen by the naked eye.. he uses a 20 g to take out the juice.. should he use something bigger.. would a 23 suffice?

**Bizz** · 11-15-2005, 08:15 PM

don't ever inject that that could cause a bad infection and maybe a surgery..so buy whatman filter .2 and your good to go...

Bizz

**tonytone** · 11-15-2005, 08:27 PM

Originally Posted by Bizz

don't ever inject that that could cause a bad infection and maybe a surgery..so buy whatman filter .2 and your good to go...

Bizz

and a sterile vial..

**symatech** · 11-15-2005, 08:31 PM

My first cycle I was drawing with an 18 or 20 and it tore the stopper to pieces. Tell your friend to use a smaller pin (23g is fine). The safest route would be to filter it into a sterile vial, I never use a .2 only .45 and never had problems but to each his own. It's a fairly common thing and some guys never filter it b/c the chunks are too large to get sucked into the syringe, but best to play it safe and filter.