HCG, Please help

[Jack Rabbit Slim]

I have these two vials one is the bacteriostatic water and the other is the powder hcg . It says 10,000 usp units. How many cc's of the water do i mix with the powder?

[oldman]

You can mix in as much as you want you just have to divide the doses according to how much BA you add.

Example:

Using a 3CC syringe, fill it with 2-1/2 cc of bacterial static water and inject into the bottle of HCG with the white powder in it. Put the needle into the bottle at a 45 degree angle and hold the bottle slightly sideways so the needle almost touched the side of the glass and the water does not “spray” directly into the powder and make it foamy and cloudy. DO NOT SHAKE IT! Swirl it if you have to till it is one clear color. Then it must stay in the refrigerator after it is mixed. What this does is dilutes 10,000 IU’s by 2.5 cc of water = 4,000 IU’s per cc and each insulin syringe (small one with orange cap) is one cc. If you are to take 1,000 IU’s per shot, you will fill up the insulin syringe to the 25 mark.



Hope that helps

~Old

[Rolsroyce]

I use 10cc water so it comes to 1000 units per cc

[01dragonslayer]

I have these two vials one is the bacteriostatic water and the other is the powder hcg. It says 10,000 usp units. How many cc's of the water do i mix with the powder?

The more bac. water you use the easier it will be to measure. I like to dilute my HCG at 500iu/ml. You will need an empty sterile vial to help you with the conversion.

[Jack Rabbit Slim]

thanks

[Kale]

BTW...the water you need to reconstitute HCG is bacteriostatic water.

Calculating HCG:

There isn't a specific ratio of cc/ml to IU. It depends on how you mix it. It's quite simple. If you dillute 5,000 IUs HCG with 5ml (cc) solvent, the end result is 1,000 IUs per ml (cc). Divide the same 5,000 IUs with 10 ml (cc) and the end result is 500 IUs per ml (cc). Therefore, a large part depends on the concentration of HCG per ampoule or vial.

Mixing HCG:
(Items needed: bacwater h20 and some 5ml emty vials-get****).

1) Open hcg/amp with powder
2) Use a syringe to pull out 1cc of BacWater and put in amp with HCG
3) It will instantly dissolve
4) Then Use an empty 5ml vial (sterile and sealed) put 4ml of Bacwater in the vial
5) Take syringe and ad the mixed HCG solution to the 5ml vial
6) Shake it and you have 5000IU's of HCG
7) Than draw 1cc and inject
8) put the rest in the refrigerator

•The reason your discarding the amp of solvent cause its made for 1 times use and you wouldn’t be able to refrigerate it and use it a week later again. That’s why you need Bac H2o.
•The most common side affect associated with HCG is gynecomastia . The concurrent intake of Nolvadex with HCG prevents gynecomastia, prevents/minimizes leydig cell desensitization and contiues the stimulation of pituitary LH once HCG has been discontinued.
•HCG will last approximately 30 days if mixed with Bac h2o instead of the solvent it comes with.
•You can keep the mixed hcg in vial or pins In the fridge till use