okay i odered some hcg and it came in 2 vials one is powder and one is liquid?? do i just ix them to gether in the syringe or what????
okay i odered some hcg and it came in 2 vials one is powder and one is liquid?? do i just ix them to gether in the syringe or what????
bump![]()
HCG needs to be reconstituted. Depending on the dose you plan on using will determine how much more bac water is needed as it makes it much easier for measuring. You will also need an empty sterile vial as well.
so i need a empty sealed vial and bac water??? and then i mix the powder and the liquid(hcg powder and liquid) in there????Originally Posted by 01dragonslayer
i usually mix it inside the vial which contains the powder - you will find that it dissolves easily in bac water , so just mix some bac water (around 1ml or so ) with the powder then draw this transparent solution into the sterialised vial and add some more bac water according to your dosage .
hope this helps
okay so the powder i got is hcg and the liquid i got is bac water or hcg solution????
i would like to do 500ius so how do i measure that in a syringe??
Last edited by clements22; 05-26-2006 at 01:37 PM.
For easier measuring you will need more bac water and an empty sterile 10ml vial.Originally Posted by clements22
How many IU of HCG do you have??
5000ius
okay but how exactly to u measure such a small amount??? would it be like one line on a syringe
It will be dependent on how much bac water you use to reconstitute....the more you use....the easier it will be to measure.Originally Posted by clements22
If you have 10 total ml...thats 500iu/ml.
OK. this should make it simple.
mix 1 ml of BA water in the powdered HCG amp. It will dissolve intstantly.
suck it up into a syringe and then gently move it into the sterile vial. Add 4 more cc of BA water (5 total).
Now 1 cc = 1000 iu.
If you want to shoot 500 iu, then shoot 1/2 cc.
Keep it cold and use a slin pin.
Originally Posted by MAXIMA5
![]()
do you have to add the BA water to it ot can you just mix the solution with the powder and inject THAT?
please somebody??
i would order some bac water,i was 2ml short and used evian instead not recommended.![]()
is any water necessary since it will already be a liquid after it's mixed? If I HAVE to get the BA water, where is the best place to get it? Would a pharmacy have it OTC?
Originally Posted by Superhuman
Yes, you need to order BA water. You cannot inject 5000 iu at one time. Throw the solution away that came with it and use BA from the board sponsor. They'll ship it extremely quickly. Follow the procedure I listed above for mixing. Swifto also answered this in several other threads.
You need the extra bac. water so that it will be much easier to measure your desired dose.Originally Posted by Superhuman
so could i just use the powder and liquid that I got without the BA water it would just be harder to measure? reason being I can only get BA with prescription in my state and I would rather not wait for shipping, thanks.Originally Posted by 01dragonslayer
Why not? I always kick start my pct with 2x 5000iu injections (three day gap between each) then 2nd week 5000iu then 3rd wk 1500. All with clomid of course.Originally Posted by MAXIMA5
HCG is meant to familiarize your tested with LH. Anything over 1500 is overkill, IMO. More is not always better.Originally Posted by Homeguard
An average dose of HCG during a cycle is between 500iu to 1000iu every week to every other week while on a cycle. In one study I looked at, a single injection of 6000IU of HCG elevated test levels for 6 days. That's why a lot of people recommend taking it every 3-5 days. We'd have more stable blood levels, though if we shot it more frequently. Remember, it's non-estrified and a water-based injectable, after all. In that same study I just spoke of, 1500IU of HCG shot test levels up between 250 and 300%. Taking it all at once however will cause an increase in estrogen levels caused by the aromatization of normal testosterone, the result may be a case of gynecomastia for the user (3). -
Anthony Roberts
Last edited by MAXIMA5; 06-03-2006 at 10:26 AM.
ok, if you are hell-bent on using your solution and not diluting, then you could possibly make this work.Originally Posted by Superhuman
Use a slin pin and remember,
500iu is now only .1 CC
Appreciate what you're saying m8, and I have to agree. However, I am old school and it has worked for me over the past summat summat yearsOriginally Posted by MAXIMA5
You are bang on the button when you say "more is not always better" but sometimes it's "better the devil you know".
Cheers for replying bro'.
Cool. Good discussion.
okay I did not get the BA water and just used the water it came with. MIXED it was about 1mL, so I used an insulin syringe and measured out .25mL which would be 1250ius. I'm going to spread it out by 4 days (4 shots of 1250ius 4 days apart) It was painless and I feel great! I shot in my stomach and expected pain but there wasn't any. Thanks for the help guys.
You should notice an almost immediate reaction to the hcg within 24 hours if you were experiencing any atrophy at all before you used it.
oh i did, I had an awesome workout today! did chest, repped 405 no problem. (410 was my max last year) I feel this more than I felt my prop last cycle!
I meant an immediate testicular reaction. As far as I know, HCG doesn;t help me with strength or endurance at all.
There are currently 1 users browsing this thread. (0 members and 1 guests)