today i did 1cc of 300mg deca today with a 23 g 1inch pin, and when i checked out the site after a couple seconds after the injection, it looked like there was some gear that leaked out...should i be concerned?
Associate Member
today i did 1cc of 300mg deca today with a 23 g 1inch pin, and when i checked out the site after a couple seconds after the injection, it looked like there was some gear that leaked out...should i be concerned?
Retired Vet
It's fluid rejection and it is normal. You can leave the pin in for a little bit (10 seconds or so) and then remove it. Quickly massage the site with an alcohol swab and it should be fine.Originally posted by MeatHead03
today i did 1cc of 300mg deca today with a 23 g 1inch pin, and when i checked out the site after a couple seconds after the injection, it looked like there was some gear that leaked out...should i be concerned?
Junior Member
you don't have to leave the needle in, take that s**t out as soon as your done pushing the gear. JUST PUT PRESSURE OVER THE HOLE, AND MASSAGE THE AERA FOR A FEW SECONDS.
Member
I just have a bandaid ready for post injection, mostly b/c I am a bleeder but also b/c I have a lot of scar tissue and the shit dont seal up very fast and I lose some gear. not enough to make a difference in my cycle, just enough to make a mess...lol
Associate Member
so just to clarify, if there is some comming out, dont worry about it cause its not enough to effect anything???
Member
YA your good to go
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
Reply With Quote