injecting problem

[walkfast]

as iam on 350mg /week of test-enthe.using 2ML syringe for inject 1 ML of test -enth. due to oily nature of it , i feel difficulty and it is taking more time in putting it on syringe what is the cause of this .am i using wrong syringe or any think else?

thank you

[QuieTSToRM33]

Are u saying that it is taking a lot of time to load the syringe or to shoot the gear into u ?

Try using an 18 guage to load the syringe, then switch to a 23 to shoot.

[HORSE~]

Try heating up the oil before you draw

What size needle are you useing to draw with try an 18g

[test=magic]

whats ur syringe size meaning how many cc chamber & needle gauge

[lzicc]

Use an 18 or 20 gauge pin to draw with. If you are pulling 1ml of test from a vial and not an amp, first pull about 1.2 ml of air into the syringe, stick the syringe into the vial, push the air into the vial and draw the oil in. Putting air into the vial gets rid of the vacuum.

[walkfast]

hello to all
sorry for late post.
thank you all for your sugegestions.as iam using 23 gauge for pullingbut as you all said to use 18 gauge for pulling i will try it at next injection time.


hello lzicc
your suggestion looks good i will also try this.

thank you

[MAXIMA5]

Yes, as Izicc said, inject air first.

If you don't have 18G, just be patient drawing with the 23. It doesn't really take that long, I do it this way most of the time. I give myself at least 5-10 minutes per injection including prep, sanitizing, drawing, shooting, massaging, and disposal.

[topvega]

Putting the vials in a bowl of hot tap water for 5 minutes will enable you to draw quickly even with a 25g pin... I've done this when I ran out of 20g pins...