I have a two part question:
The first is why is it so hard to fill my syringe with 1 ml of Test e?
I have a 10ml syringe and I am using a 25gx1" needle to draw from. My test e is in a glass vial with a rubber top. I heat up the test e in hot water before I draw. When I draw the test e I fill the syring with about 2 ml of air and then insert into the glass vial. I push in the air and then draw my test e. I pull back on the syring to about 6ml and the vacuum is so strong I can barely hold it there. It takes about one minute for me to get 1ml of test e. Am I doing this wrong? or is this normal?
Second question is why is it so hard to inject. I am using the same 25gx1" needle to inject into my thigh. When I inject I have a hard time with pushing hard enough on the plunger. It takes about 45s of pushing as hard as I can to get 1 ml into my thigh. I have to push so hard that my thumb hurts worse than the injection site. Should it be this hard? Or is it because I am using a 25g needle?