Results 1 to 8 of 8
Thread: Injecting Ques
-
08-04-2006, 09:16 PM #1New Member
- Join Date
- Aug 2006
- Posts
- 9
Injecting Ques
I just took my first shot of sus 250 and had a hard time getting the sus in the syringe. I wasted more gear then need be b/c it took like 10 minutes to get 1cc out the bottle. Any suggestions?
-
08-04-2006, 09:19 PM #2
What size needle did you use?
Was it a vial with a rubber stopper or an amp?
If vial, did you first add air in the amount you were drawing to create pressure to make it easier to draw?
I usually draw with an 18g needle and shoot with either a 23-25g
-
08-04-2006, 09:19 PM #3
draw w a larger pin
-
08-04-2006, 09:22 PM #4New Member
- Join Date
- Aug 2006
- Posts
- 9
it was a vial with a rubber stopper and the pin was 23 gauge
-
08-04-2006, 09:25 PM #5
should not be too hard w a 23 g...
-
08-04-2006, 09:26 PM #6Originally Posted by the virus
Well that could be your problem then. It will take longer with a skinny needle cause the oil is thicker. couple things to try
1. warm up the oil in a cup of hot water
2. get larger needle 18g works great
3. inject air into the vial in the amount you are drawing to help create pressure to force the oil a little quicker
either way take your time and be patient. good luck and WELCOME TO AR
-
08-05-2006, 01:35 AM #7
I used 18 g but sometimes it took off part of the stopper and dropped into the liquid.. I will try 21g from now on..
-
08-05-2006, 01:42 AM #8
Even a 21g with air pushed in loads pretty fast.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Cytomel dosage ?
05-15-2024, 09:31 AM in ANABOLIC STEROIDS - QUESTIONS & ANSWERS