Winny injection problem! PLEASE HELP!!

[Ddub]

I have been taking winny eod at 50mg. I have probably wasted around 1 1/2 cc so far. The problem that is occuring is it seems the needle is getting clogged very easily. I am using a 22 gauge, its hard to draw out and when I do get it and inject I can only get a couple og lines in and it stops. Then I pull out and try to push it through and it ends up almost shooting to the ceiling. I shake it up extremly well and now I have tried heating it, and still have not got any luck with it corporating with me. Any advise would be extremely thankful!!

[briansauras]

are you injecting air into the vial before you draw?

[Ddub]

Im not drawing any air into to but air bubbles come in and I thump them to the top and push the bubbles out.

[stuball]

Im not drawing any air into to but air bubbles come in and I thump them to the top and push the bubbles out.

I dont think that was his question, are you pushing air INTO the vial, before you pull the juice out ???

[Ddub]

oh my bad, no Im not pushing air into the vial, if I was what would that cause

[MuscleHeadz]

u might want to consider using an oil injectable first to oil lubricate the needle going in.. I found that helps...

[jollygreenGIANT]

why dont u just drink it?

[Huckster]

why dont u just drink it?

Ya, I think I heard you could drink winny!

[Ddub]

what are the steps of the oil injectable, not very familiar with that?

are the effects the same for drinking winny or does injecting it works better?

[clozr]

I have had the same problem. Just switch needle out (Not the whole pin, just the needle. Put the cap back on and twist to take it off, then just twist on a new one.) and give it another go. It should be just fine. Your ceiling will thank you.

[briansauras]

Um vials have a vacuum in them. if you do not inject air into them it will be very hard to pull anything out. just pull back the plunger on ur pin before u put it in. insert and push the plunger all the way down and then the oil should literally get into the syringe itself.

[skipp]

oh my bad, no Im not pushing air into the vial, if I was what would that cause

It would make it easier to draw out, try it. It will work.

[briansauras]

curtousy of SI.com

*For drawing from a vial:

***ALWAYS wash hands before injecting***

Wipe the top of the vial with an alcohol swab before the needle enters - do this every time you pull the bottle out from storage (do not blow on the top of the vial. Let the alcohol evaporate)

Pull back on the syringe approximately as much as you are going to fill it (i.e. - if you are going to draw one cc then first load one cc of air) poke the needle into the vial.

Inject the air into the bottle so that you have created a vacuum effect and drawing will be easier

*Pull back on the plunger until the desired amount is achieved (you may do this with the bottle upside down so that you can 'flick' the syringe to get the bubbles to settle while you are still in penetration.

*Once you have the amount you are looking for you will either (A). be ready to switch needles or (B). you may leave the needle on for pulling from another vial if you are going to mix

*So (A). you will pull back on the plunger once you are out of the vial to get the remaining liquid out from the drawing needle's base

*Poking the needle in to the vial dulls it. At this point you may want to switch to a fresh (sharp) needle.
You have now drawn from the vial.


honestly if you have to ask this kind of question you are not ready to cycle. another way I can tell is that you are injected winny eod. ill take another wild guess. since your question is about drawing from a winny vial i bet you are running winny alone.
how old are you?

[pumpd4lif]

u know what worked for me i had the sam problem and i would just keep trying to aspirate untill that puppy broke lose but also as soon as u withdraw it from the vial inject dont let it sit in the needle.
i withdraw put about 1/2 cc of air insert, aspirate ,inject ,

[LatinoPR]

go with a 21g...that's the only needle that can use when i was running QV Stan 100.