Floating in my Gear!

**MRRoboto** · 12-01-2006, 08:51 AM

Well, its not actually floating. I just finished transferring my testC (four 5ml sachets) from my sachets to a sterile sealed 20ml vial, when I notice a small spec slowly settling to the bottom of the vial. I think I may have lanced a piece of the sachet with my needle. It's no bigger than a flea and could be easily avoided when drawing because it sits on bottom. First, I dipped the sachet into a bowl of 50% alcohol then wiped the puncture area with an alcohol pad before inserting needle into sachet. I used a new needle for every penetration. What now? Toss it?

**AnabolicBoy1981** · 12-01-2006, 09:00 AM

did you filter it?
this woudnt have happened if you filtered it.
i would buy a filter from ar-r , and i new sterile sealed vial, then filter it into the new vial.

or if you wanna be a lazy ass, you could try suckin it up with an 18 gauge needle.
all supplies can be bought through ar-r

**MRRoboto** · 12-01-2006, 09:06 AM

Originally Posted by AnabolicBoy1981

did you filter it?
this woudnt have happened if you filtered it.
i would buy a filter from ar-r , and i new sterile sealed vial, then filter it into the new vial.

or if you wanna be a lazy ass, you could try suckin it up with an 18 gauge needle.
all supplies can be bought through ar-r

GOOD IDEA! I have another vial and a couple .45 whatmans. Will that do?

**guest589745** · 12-01-2006, 10:15 AM

Man I had the 18g pin poke pieces of the rubber seal into my vial! I can't get that shit out for the life of me! I am just gonna be careful and try to not suck it up, maybe get some vials and transfer it with a 23g pin though.