Boiling Test E to remove alcohol

[BigNicky]

Hey guys ..was talking to a buddy at the gym about problems with my Test E injects( Pain and swelling after about three days that eventually went away). He mentioned he had similar problems and perhaps the batch had too much alcohol in it. He suggested boiling it to remove the alcohol. Can anyone please give me some advice if this is feasable. Will it ruin the efectiveness of the stuff. Thanks

[Unoid]

Good idea, go damage the hormone!

[kynetguy]

Hey guys ..was talking to a buddy at the gym about problems with my Test E injects( Pain and swelling after about three days that eventually went away). He mentioned he had similar problems and perhaps the batch had too much alcohol in it. He suggested boiling it to remove the alcohol. Can anyone please give me some advice if this is feasable. Will it ruin the efectiveness of the stuff. Thanks

No its not feasible nor is it remotely a good idea.

Alcohol is what maintains the sterility of the injectable. UNless it was made with more than 5%BA, then its highly unlikely your problem.

Test E disolves very easily into oil alone. They only thing really needed is 1 or 2% BA to ensure sterility. So unless someone had no clue what they were doing when they made the gear, alcohol is not the issue. But I would have to see the actually recipie to have an intelligent answer beyond "boiling is a bad idea.

[evil pepsi]

No its not feasible nor is it remotely a good idea.

Alcohol is what maintains the sterility of the injectable. UNless it was made with more than 5%BA, then its highly unlikely your problem.

Test E disolves very easily into oil alone. They only thing really needed is 1 or 2% BA to ensure sterility. So unless someone had no clue what they were doing when they made the gear, alcohol is not the issue. But I would have to see the actually recipie to have an intelligent answer beyond "boiling is a bad idea.

get some sterile grapeseed oil, and mix it with your test in a 1:1 ratio, and just remember to double your dose to get the right amount...

[guest589745]

low heat is fine but boiling will damage the hormone and render it at least partially useless as far as I know.

[Maldorf]

By boiling he meant to boil some water in a pan and let the vial sit vented in it. The water will boil at 100 degress celcius and not go any higher so that the hormone wont be damaged at all. Only thing is, I dont really think this works so well. Very little BA actually turns into vapor and leaves the vial.

[BigNicky]

Ok guess I wont be cooking my gear..lol..Thanks gentlemen.

[guest589745]

Literally boiling is a bad idea, low heat is safer.

[BigNicky]

Tell ya what ive been doing...heating a clean mug full of H20 in the microwave...then holding the vial till it gets nice and warm in it...sterilizing the top before and after . Ive decided against the boiling with a pin sticking out as a friend suggested.

[taiboxa]

wow ..

[RobbieG]

wow ..

Excactly.

it´s probably not the BA, just a virgin

[MuscleScience]

I have the same problem with pain from test e, my muscles have been injected before So I know its not my lack of injections history.

[andros00919]

Man sorry , But you are Crazy? You f......k the compound!
Are you have pharmacy quality controls in your house??

Try other thing!!