Chest Injection

[Knockout_Power]

just wondering what depth to go on pec injection. Ive only done glute and quad so far.

[pigrond]

depends how thick your chest is 1/2" should be plenty i personally dont go more than 3/4" in

[LeadPencil]

depends on your chest size i go no more that 1 inch but everyone is different

[aadrenaline]

i think it depends on how thick your chest is, how my fat there is. i would think half inch would be fine for most people. my one friend shoots everywhere with 5/8 but hes got not an ounce of fat on him.

[aadrenaline]

lol we all posted at the same time.

[Knockout_Power]

first cycle, not a whole lot of chest size yet. Just feels like the bone is so much closer than .5 inch

[aadrenaline]

take a picture...then why do you want to shoot chest?

[pigrond]

if your shooting your left pec reach your left arm under your right arm pit area that should fatten it up enough to shoot.dont flex your just trying to bunch up the muscle poke the thickest spot and look out for veins they hurt

[Tesla]

first cycle, not a whole lot of chest size yet. Just feels like the bone is so much closer than .5 inch

If it's your first cycle, just stay with your glute. There's no need to get fancy with your injections.

[pigrond]

If it's your first cycle, just stay with your glute. There's no need to get fancy with your injections.

this is very true

[kaberle_15]

It is good to switch injection sites............try delts?

[Knockout_Power]

If it's your first cycle, just stay with your glute. There's no need to get fancy with your injections.

I have been having problems with injection pains from over shooting the glutes. Some board members were guessing too much alcohol in the Test and most people told me to rotate sites to give each site more than a week recovery. Right now, after each shot, I develope a hard lump about the size of marble that stays about 5-6 days which never goes away cause the next injection is day 7. Its week 8 so I thought I would mix it up a bit.

Following pigrond's advice, I can easily go ¾" depth. I was just following the procedures on www.siteinjections.com and it shows a basic injection.

[pigrond]

you can also check out spot injections . com good info there

[Knockout_Power]

that be the one, your advice was better