leaving gear in syringes...

[amature225]

How long is ok to leave gear in syringes? Can I pre-fill 10 days worth (into 10 syringes)?

They will be kept in the same cool dark climate as the Vials would.

any info would be helpful, and this would obviously cut down on drawing out of multiple bottles daily.

[anaBROLIC]

yes you will be fine. not a problem.

[THE JU-ICE]

Mt friend loads 2 months worth at one sitdown.

[unclemoney]

Hmm the idea just crossed my mind... Say preloading however much you want (but reusing the same needle for each syringe to preload) therefore you'd save on needles rather than using 1 to withdraw then another 1 to inject.

[Mighty Joe]

I've done a weeks worth at a time..

[THE JU-ICE]

You grab an 18 gauge and just keep putting it on the 3 cc tubes.1 spike that draws fast and your preloaded for weeks. Store appropriately.

[Valac]

i dont like preloadin, i know it saves time and what not but i like to be sure that everythin will be sterile.

[steggs]

i dont like preloadin, i know it saves time and what not but i like to be sure that everythin will be sterile.

i agree will they stay sterile

[Midwest Viking]

I don't see the point in preloading. I mean, it saves a little time, but, it doesn't take much time to do everything each time, plus, it seems by taking all the steps each time you shoot, it would be safer, and you are less likely to forget or miss something. Unless your schedual is just so ridiculously crowded, that you have absolutely no time to draw out the amount, etc, each time you shoot.

[THE JU-ICE]

If your washing your hands,using alcohol wipes and opening the spikes your self, how would they not be sterile.I call it profesional. If you buy anything preloaded its more expensive.If your in a situation where you cant properly store your gear then dont do it.If not its a great way to get the job done.

[celticd]

id loaded up my syringes with test cyp recently because it was from a 5ml sachet so it had to be done,i went to do my last shot 2wks l8r and there was all these little crystals floating around,so i binned it,turns out cyp has a habit of crashing so it would have been ok to do

[Marty_4]

Is it ok to store vails on teh fridge?

[anaBROLIC]

Is it ok to store vails on teh fridge?

why would you want to. you dont need to.

[Dizz28]

You grab an 18 gauge and just keep putting it on the 3 cc tubes.1 spike that draws fast and your preloaded for weeks. Store appropriately.

This is a good way to do it. I've done it this way before. I had an 18gauge drawing pin and used it to draw up 20 amps of Galenika Test E's into individual 3cc syringes. Once the amp was drawn up, I replaced the 18g with the origional 23g pin and stored them until needed...saved time. Even with a 23g it takes a while to draw up even an amp of oil.

They should stay sterilelike that. That's why there is BA and BB in it to be preservatives. No need to put in the refrigerator either. Keep it room temp until you are ready to use it

[IAMCDN]

i'd like to pre-load my tren ace since i'm gonna be doing it eod. i'll probably load a week at a time.

[Dizz28]

i'd like to pre-load my tren ace since i'm gonna be doing it eod. i'll probably load a week at a time.

I've only preloaded when I'm using amps because they are a pain in the a** compared to multiple use vials. Vials are easy to draw from so I've never preloaded if I was drawing it from a vial...but everyone has thier own approach to things. If you want to do it...go ahead. Just make sure things stay as sterile as possible and change the pin out after you draw it.