Sachet Idea...makin it easy :)

[domeyeahaigh]

What ya'll think of this idea?

Sterilize a small saucer of some sort and empty sachet out into saucer...suck up with syringe then put in vial

How can I make this idea better?

[Sir Lifts-a-lot]

[QUOTE=How can I make this idea better?[/QUOTE]

By not using them to begin with

[jaysunderstudy]

that is not the way u do it. I just got mine in and i took about 20 min to extract the oil out. I got mine in a record 7 days and i'm back on cycle ready to start. Its really the only way i feel safe ordering now. Plus they are cheaper than vials and get here faster. But u need a 18g needle and an empty sealed vial its not that hard dude just gotta be patient and do it right. jus don't get the 3.5 ml sachets either 5 or 20 ml and u'll be good to go.

[scaramouche]

What ya'll think of this idea?

Sterilize a small saucer of some sort and empty sachet out into saucer...suck up with syringe then put in vial

How can I make this idea better?

lmao,by never doing it,how the fuk r u gonna sterilize a saucer lol,just filter into sterile vials like everyone else

[Big]

Just make something to hold the sachet upright on a table, stick the needle in it (making sure you swab the area with an alcohol swab first) draw out the substance and inject it into a sealed sterile vile. May take just a bit of practice, but it really isn't that hard.

[Sir Lifts-a-lot]

follow the instructions they have on their site.

Oh ya, if you haven't used these before get ready for some pain!!!!

[domeyeahaigh]

I injected in my bicep it hurt like a ****ing bitch but i am okay now
.

[skank]

Just make something to hold the sachet upright on a table, stick the needle in it (making sure you swab the area with an alcohol swab first) draw out the substance and inject it into a sealed sterile vile. May take just a bit of practice, but it really isn't that hard.

And don't forget to vent the sterile vile with another needle. Otherwise you won't be able to fill the vile because of too much pressure.

[Big]

And don't forget to vent the sterile vile with another needle. Otherwise you won't be able to fill the vile because of too much pressure.

excellent idea, I just drew a vacuum on the vial just before injecting, but I like your idea better.

[domeyeahaigh]

hehe actually you know what that is all very easy i did get a nice amount wish i woulda known that the first time...oh well i was too excited

[BuffDJ]

If you can I would recommend getting you hand on a few 14G IV Caths. These are sterile but they are rubber and wont punchure the satchet and will draw the oil up quickly. I enjoy using satchets. I just don't enjoy the drawing it up and putting it in vials. Label vials. Vent vials just on and on.
Buff

[theflyzman]

I never had a problem with yet

[ecto9]

And don't forget to vent the sterile vile with another needle. Otherwise you won't be able to fill the vile because of too much pressure.

Hey I thought the sealed vials are vaccumed sealed...?

[Big]

Hey I thought the sealed vials are vaccumed sealed...?

Yes, but a 10ml vial may not necessarily have enough vacuum to accept 10ml liquid without building pressure. If you took a sealed 10ml vial and extracted the equivalent of 1ml air, technically it would be in a vacuum inside the vial, just not a sufficient vacuum for the injection of 10ml liquid.

[pigrond]

sterilize your satchet with alcohol get big assed 30 ml syringe with an 18ga needle suck all of your satchets dry or at least 30 ml worth twist on the filter grab fresh 20 or 30ml vile insert aclean needle for venting grab caulking gun load the syringe into the gun pop the vile on the end and give the gun a sqeeze. it dont get much easier or cleaner than that.

[domeyeahaigh]

sounds good but I did just use something to prop it up, then I stuck the needle in the top it was a 22g 1.5 in. pin. It only went in about half way but it sucked up 5.5ml no problem... this was very easy and I did not have to stick the pin any further than halfway it was very good about sucking everything out...also I sterilized it all first

[Big]

Good deal, glad it worked out for you.

[Nitz5785]

sterilize your satchet with alcohol get big assed 30 ml syringe with an 18ga needle suck all of your satchets dry or at least 30 ml worth twist on the filter grab fresh 20 or 30ml vile insert aclean needle for venting grab caulking gun load the syringe into the gun pop the vile on the end and give the gun a sqeeze. it dont get much easier or cleaner than that.

This is basically what I did and it worked out great. I only had a 12cc syringe though but it went pretty easy.