6g fina conversion problem, PLEASE HELP!!

[MAX30]

Okay here's what's happened. I crushed and dissolved the pellets no problem. Then I go to add vial "A" to vial "B" and there is too much oil in vial "B", some spilled over. WTF. Since all the fina went straight to the bottom and didn't really mix yet am I still ok? Please all input is needed at this point. CHEM if your out there I'd love to hear your input also.

MAX30

[MAX30]

Well I went ahead and finished the job assuming this happens and ended up with 57ml of perfectly colored trenbolone acetate. I still don't think I lost 3ml but it's hard to gauge when it's running over the side. hehe. What do ya think guy's is it fine? Bump...

[Buddha_Red]

it should be totally fine.

next time just remove around 5ccs or so before you start. i use it to clear my whatman filter.

hell i lose a little bit each time by one way or another.
Feed them cows and let us know how its cycle goes

[MAX30]

Thanks Buddah, I figured it probably would be ok. By the way I did take out 5ccs so if anybody else out there is going to convert a 6g kit you may want to take out about 10ccs.

So how's the fina treating you on your current cycle?
MAX30

[Gear101]

next time if it doesn't all fit into b.. just use the extra oil to clean out the what fitlers.. no biggy.. after you do it a couple of times it will get easier...