what gauge needles for test susp??

[STED]

Ive got a vial of test susp, ive got 23 guage needles at the minute and im struggling to draw the compound up evenly, im drawing more water up than test powder! Anyone help? thanks in advance

[kfrost06]

Ive got a vial of test susp, ive got 23 guage needles at the minute and im struggling to draw the compound up evenly, im drawing more water up than test powder! Anyone help? thanks in advance

something is wrong with your compound/mix, i.e. it's no longer in a suspension if the powder and water are not homogeneous.

[kfrost06]

Something has happened to "kick out" the test from the suspension. I would try the lab section to find out how to get it back into a suspension w/o destroying the testosterone. Normally a very small needle like a 25+gauge is all you need for a water based compound.

Good Luck!

[STED]

the test susps fine, it just needs a shake before you draw it up, it always settles when its left, it just doesent draw up through small gague needles, ive read up it clogs

[kfrost06]

whats the strength? i.e 100mg/ml, 200mg/ml?

[jstraw428]

So just draw with something like a 20 gauge........and then shoot with your 23g.......

[muaythaiguy76]

i wouldnt draw with anything larger than a 21 especially with 20ml jugs of suspension or prop or any compound you shoot ed or eod ive had peices of rubber from 20 gauge needles drop into the jug

[STED]

Its 100mg per mil, test susp in a 20mil vial. and im struggling to draw up with 23g inch needles. Anyone any experience with this kinda stuff?

[muaythaiguy76]

shake it up a bit before you draw it

[LatinoPR]

I draw everything with 18g.Youll never going to get nothing thrue a 23g.










LPR.

[T3/T4 GSR]

I draw everything with 18g.Youll never going to get nothing thrue a 23g.










LPR.

I have gotten lots of oil through 25gauge pins before....water should be able to go through a slin pin no problem.

[Nicotine]

for sust oil suspension, i drew with 18, shot with 23. (25 too, but it was much harder)

[logen32]

run it under hot water and that should help a bit

[jstraw428]

....water should be able to go through a slin pin no problem.

I think Pinnacle, has a recipe up for 100mg suspension that he was using a slin pin to inject.....

[HAFdawg]

Warming it up in some hot water should help out with drawin it up without any clogs

[LatinoPR]

I have gotten lots of oil through 25gauge pins before....water should be able to go through a slin pin no problem.

Trust me on that one,water has more particles than oil.You can inject oil thrue a 23 or 25 easy...



...im been on this game for a good time.











LPR.