Test e gone bad

[big83]

I have about 50 amps of testoviron depot transfer into a sterile vial, it has been there for 6 months. the expiration date is good, but it became really thick while going through the needle, and really hard to push once it is in the syringe.

do you guys think it went bad, and is there any way to recover it, any sugestion will be apreciated it.

Thanks

[god-send]

sit the vail in a glass of warm warter from a couple of mins ,this will thinin out the oil and make it alot easyer to draw and shoot.

[redz]

Why would you open 50 amps and put them into a vile? Seems like a bad idea to me.

[god-send]

yer as above seems strange to open all them amps and put in a vail.

[big83]

i was terying to get them across countries and i dont think customs would had like 50 testoviron amps.

Do you guys think if i sit it in warm water, i can still use it even if its thick.

it looks normal and clear, no crystals

[redz]

Well if you are dead set on using it try a bigger pin like a 21-22G

[Chemokine]

I don't think higher viscosity would indicate contamination. Check for color change or solution cloudiness? Is it clear?

[gehirin]

Try running the solution though a 2 micron filter. Should rid you of potential microbials in your soln. Don't forget to filter back into a new sterile vial...not the old one.

[big83]

it has a little cloudiness, but other than that it has the same color it had before.
so, should i used it?

[big83]

i did one shot the other day, and it felt fine, but dont know if i should keep doing it

[gehirin]

Personally I wouldn't use it if it had any hint of cloudiness. I would run it through a filter for ease of mind.