I think I did something pretty foolish, but anyway.. here goes
Last week, prior to my injection I used my syringe/needle to measure out 1cc of Clenbuterol. Not sure if any residual was safe to inject, I rinsed the syringe with boiling water.
Anyway, so onto the injection.. I measured out 1.2 cc of deca and then put .2 back into the vial for 1cc. Problem is, I think there was some residual boiled water in the syringe that I also may have put into the vial because you could see little bubbles in there, later getting smaller and making the deca look a bit hazy.
Anyway, almost one week later and the deca looks exactly the same: just a bit hazy. I'm not concerned about a little boiled water in my butt but would any bacteria form in the vial in an airtight scenario?
Tomorrow should be my next injection and I wanna know if I should just get another vial or if this one is ok still.
Thoughts?