So i bought everything for my cycle of test suspension, im keeping it mildy low dosage, 25mg 2Xday. well i bought 100 28g 3/4X1ml slin pins, well i tried drawing with those, and can only get a very little amount before it clogs, so i thought hell, i had one more 3ml, 23g 1 1/4 needles and syringe, so i decided i would draw with that then pull the needle off the drawing syringe and then the plunger outta the slin pin and transfer the test and inject with the slin pin, well it worked ok, but i have to have my injection site swabed, then shake the hell outta the slin pin, and stab myself quick and inject fast and it works ok. now i have more 23g needles commin, but for right now after i get done injecting i take the needle and syringe i used to draw with and im soaking them in a 91% isopropyl alcohol solution and running it in and outta the syringe and needle then putting the cap back in em and sealing them in a new plastic sack everytime, now i will prob have to do this for about a week before i get my other needles, but do you think this will cause any problems until then?? this is my first time using suspension, and im not to fond of injecting twice a day with a 23g, so any advice would be great until then, thank you