this can't be good...

[Hunter-S-Thompson]

so I'm about 4 weeks into a cycle of test cyp.. I drew my test into a syringe the other day to measure how many shots I had, then put it back into the vial. i just looked at it a few days later (today) and it turned into goo on the bottom of the vial... like half goo and half liquid... I shook it up for like 5 minutes and it returned to normal besides a tiny bit of goo stuck on the very bottom. wtf happened to my test!?!?

[Hunter-S-Thompson]

bump... anyone?

[AnimalGear]

ummmm no clue...bump for help. I've never heard of test doing that

[T-MOS]

sounds like it crashed. you can try to heat it up double boiler style until all the hormone goes back into suspension

[Seattle Junk]

sounds like it crashed. you can try to heat it up double boiler style until all the hormone goes back into suspension

Ditto to that... yep, your suspension crashed...

[Mammon]

whats with all this gear crashing lately..

[MMArmour]

drunk drivers. chuckle. chuckle.

[T-MOS]

drunk drivers. chuckle. chuckle.

Moral of this story.....Don't drink and drive while on gear, or it will crash!!...lOLOL

[MMArmour]

The test is a booze hound! i can barely contain him!

[Hunter-S-Thompson]

ok cool thanks guys .. tmos how do I heat it "double boiler style" lol.. also I had to inject with it after I shook it is that bad :/

[T-MOS]

ok cool thanks guys .. tmos how do I heat it "double boiler style" lol.. also I had to inject with it after I shook it is that bad :/

double boiler, meaning you don't want to stick it directly over a flame, you want to put the vial in a water bath.

heat water put vial in water, keep vial off bottom of pan so not to be in direct contact with metal.

there may be a better explanation in the Lab forum here.

[Hunter-S-Thompson]

ok cool I'll look into it thanks bro

[jfalco]

if you want you can just hold the vial in the steam. that way you're sure not to heat above 100 C.

[Hunter-S-Thompson]

if you want you can just hold the vial in the steam. that way you're sure not to heat above 100 C.

how long should I hold it for? it looks pretty much normal as of now since I shook it so I can't really go by how it looks

[drive it!!]

ive had to do this before and it works well. place a pot of water on to boil and put the vial inside a shot glass. the water lever should be just below glass so the vial cant float out but let some of the boiling water fill the glass. the gear will look like new in a minute or so.

[Hunter-S-Thompson]

ive had to do this before and it works well. place a pot of water on to boil and put the vial inside a shot glass. the water lever should be just below glass so the vial cant float out but let some of the boiling water fill the glass. the gear will look like new in a minute or so.

ok cool I'll try that.. the only thing is it's a 20ml bottle I don't think it'll fit into a shot glass but I'll rig it up somehow.. thanks