Injecting Multiple Compounds

[aestheticmind]

I am going to be shooting 1ml Test E with 1.5ml Masteron at the same time in a 3cc syringe.

I have read to draw in air and inject that air into the vial, then draw the oil. But, I have to draw from 2 different vials so I could only inject air into one of them.

Is injecting the air into the vial necessary, or does it just make it easier to draw? Will I have any problems drawing without injecting the air first?

[CHUCKYthentic]

you can inject air into the 2nd 1. after you pull the oil out of the 1st vial, pull more air into the syringe... pull the plunger back to say the 3ml line, then shoot 1cc of air into the 2nd vial

i wouldnt say it is necessary, but its a lot harder without the air. it creates a vacuum like affect

[JiGGaMaN]

you could do them both easily:

draw back 3 cc, push into test e, draw 1cc

draw back to 3cc again, push air in and draw masteron

simple as that.

[hankdiesel]

Pushing the air in is just to get it out easier.

[sonysucks]

just to be clear do as jigga says , but add that you must be holding the needle pointing up so air is at the top of the syringe and its only the air that gets pushed into the masteron vial...not the 1 cc of test you just put in there....

[scerpico22]

just to be clear do as jigga says , but add that you must be holding the needle pointing up so air is at the top of the syringe and its only the air that gets pushed into the masteron vial...not the 1 cc of test you just put in there....

yup...thanks for the clarification

[JiGGaMaN]

just to be clear do as jigga says , but add that you must be holding the needle pointing up so air is at the top of the syringe and its only the air that gets pushed into the masteron vial...not the 1 cc of test you just put in there....

never even thought about doing it the other way. damn.

[Jfew44]

just to be clear do as jigga says , but add that you must be holding the needle pointing up so air is at the top of the syringe and its only the air that gets pushed into the masteron vial...not the 1 cc of test you just put in there....

Lol, I've never actually done that but I wonder how many have?

[oneshot]

nah. shoot air into test, then shoot air into mast, draw mast, then pull out of the mast vial and draw test. much easier than trying to push air out of a partially full syringe and not push out any gear which could lead to mixing your two compounds very slightly. only problem with this method is if you are shooting with the same pin you are drawing with. the extra vial stab can dull the needle and make it a bit more painful to inject

[Lean1038]

nah. shoot air into test, then shoot air into mast, draw mast, then pull out of the mast vial and draw test. much easier than trying to push air out of a partially full syringe and not push out any gear which could lead to mixing your two compounds very slightly. only problem with this method is if you are shooting with the same pin you are drawing with. the extra vial stab can dull the needle and make it a bit more painful to inject

Well let's all hope that everyone's changing pins after loading to begin with.

NEVER DRAW AND INJECT WITH THE SAME NEEDLE GUYS!

[c-Z]

Well let's all hope that everyone's changing pins after loading to begin with.

NEVER DRAW AND INJECT WITH THE SAME NEEDLE GUYS!

Draw with 23g 1 1/2 and use same to inject? It isn't all that painful?