injecting time

[mas-polloxxx]

i just transferred my gear into my vials, and i know my needles aren't as big as they will be next time, but i used 22g and it took me over 5 hours to transfer 60 ml of test cyp, tren, and primo. For using a needle of that size, does that sound normal?
On the day i have all three shots, should i just go back to back to back and sit there for an hour drawing them out and injecting?

[stpete]

Sounds about right. You need to purchase some 18's.

[(1*)]

what type of tren?
you can shoot them at once if the tank is big enough. i use 21g for drawing and injecting but have used as small as 23, it just took longer.
also you can warm the solutions to thin them out.

[CHAP]

Now that you have your compounds in vials it should onlt take a couple minutes to draw. You need to inject 1 or 2 cc into the vial then put the needle in the compound and draw it out.

[mas-polloxxx]

Sounds about right. You need to purchase some 18's.

18's for transfer only, or do u use that to inject as well

[(1*)]

18 for transfer only

[mas-polloxxx]

what type of tren?
you can shoot them at once if the tank is big enough. i use 21g for drawing and injecting but have used as small as 23, it just took longer.
also you can warm the solutions to thin them out.

Trenbolone Enanthate
you're saying draw the compounds into one syringe, separate needles, and inject it in one sitting?

[(1*)]

you could. it is not a bad idea to change pins. (this could even be easier as the needle dulls a little from the stopper) just keep it clean.

[mas-polloxxx]

thanks for the input, that was exactly what i was looking for

[Ashop]

18's for transfer only, or do u use that to inject as well

To draw/transfer ONLY!! 18g would be super painful.
22-25 gauge will typically work well for injects (we use 23g).