Drop of gear leaking out after pinning

[Berserker88]

Hey guys, this just happened to me for the first time in 8 injections, what causes a drop of gear to leak out after you pull the pin out?

[AlphaMaleDawg]

I believe it has to do with not injecting deep enough. Happened to me once during my cycle

[CHUCKYthentic]

just excess gear at the tip of the syringe, gear still comin out after injection while you re pullin out....

happens, no need to fret good sir

[Big]

also it helps to inject very slowly, give the gear time to absorb

[Merc.]

Could use the Z method also...



Merc.

[Berserker88]

I believe it has to do with not injecting deep enough. Happened to me once during my cycle

it was a 1.5" in the glute and it was almost all the way in

just excess gear at the tip of the syringe, gear still comin out after injection while you re pullin out....


happens, no need to fret good sir

Thats what I though and was hoping to be honest.

also it helps to inject very slowly, give the gear time to absorb

took about 30 secs to inject 0.7cc, is that slow enough?

Could use the Z method also...



Merc.

Was thinking about this...



Thanks for all the replys guys!

[thenextcutler]

Try leaving the syringe in for 10-30 seconds after your done, then remove and obviously apply pressure right away with your swab

[xxterxx]

it should be the gear left in the tip of the needle.. or rather inside the needle.. just a drop.. its fine

[Berserker88]

it should be the gear left in the tip of the needle.. or rather inside the needle.. just a drop.. its fine

Every drop counts



Seriously though, thanks for the replies guys.

[chuckt12345]

happens,, sometimes ill walk away and check my glute and half the shot has leaked back out,, i just put pressure on it for a minute or so,, should stay in