are there any creative ways on getting all the oil out of the vial?
i tried a few but wanted to see if the pros can suggest some technique to help aviod wastage..
thx
are there any creative ways on getting all the oil out of the vial?
i tried a few but wanted to see if the pros can suggest some technique to help aviod wastage..
thx
pop the top of the vial off, stick pin into the corners extract.
i just flip it upside down and get some good angles with the needle/.
Usually works for me.
Put about 2 ml of air in the syringe and inject it in the vial before you draw out. I know you won't be pulling out 2ml, but the pressure will help get those drops.
this will be my first option, injecting air into vial, then if needed ill try and open vial...
one more thing...if i manage to get half a ml out can i just add an additonal .5ml from my human grade stuff to make a full ml or would that be a problem?
thx
On average my syringe has 3mg left in it after I inject.
Im not going to go and put all those drops from all my needles into 1 syringe, So i dont waste any.
So why bother using plyers to take off the top of your gear vial.
Honestly
Warm the remianing oil under hot water, it will thin the oil out a bit and let it run down the vial a little easier. I just inject a little extra air and draw slowly while removing the needle from the stopper slow. Hardly a drop left when Im done.
lol stop wasting your time... get the most you can get and grab the next vial
There are currently 1 users browsing this thread. (0 members and 1 guests)