Preloaded syringes for next week...

[russiandave]

Here is what happened. As I took the metal off the top of the test cyp vial it all came off. No biggie the rubber top stayed on. However when I injected air into the vial to draw the top popped open slightly and a bit of oil came out. I quicklyyyyy closed it as it barely opened.

So after injecting I sat there looking at the vial and was concerned that it wasn't a good idea to keep my stuff in it. I decided to preload two syringes. They are basically next weeks shot. There is another syringe that is partially full and I suppose I can use that for the week after.

I preloaded the syringe and then changed the pin and put it back in it's packaging and put it away in a cool dark place.

Do you guys think it'll be ok for a week? I plan on changing the pins before I inject.

[NickyReps717]

I think it should be ok.

Put it in a zip lock bag, to seal it off from the air.

[Hazard]

It's not something i'd make a habit of but in this situation..... im sure you will be ok. I probably would have left the pin I drew with on..... and when I go to inject - swap for a new one.....

~Haz~

[ghettoboyd]

i sometimes pre-load for the next shot as i get up and inject in the am.....i get up at 2 am and its a hassle to prepare when your just getting up so its a matter of convieniance...i put it in a ziplock bag as someone suggested....never had a problem doing this, infection wise i meen...

[russiandave]

Thanks for the reassurance guys.

Haz the only reason I swapped out the pins now were because I have a ton of them and I was nervous something may possibly adhere to the oil on the older tips. No real reason otherwise.

[chuckt12345]

those pos cheap metal tops are becoming prevelant

[Knockout_Power]

Not sure if its the tops or the crimpers being made so cheaply now or maybe a combination of both.

[russiandave]

Oh a bit more info guys. I use draw syringes hospital grade.they have big plastic tips and they are made with a filter in them. That's what I draw with then I swap them off for a regular pin.

And yea those caps suck. It's like they are made of aluminum foil lol. But hey I'm thankful because without them I couldn't cycle lol

[JasonT]

on my last two vials, the metal came off half way, but the rubber seems to stay in place when i inject air....wish the plastic piece would come off without tearing the metal.

[c-Z]

Shit never had a problem with any of my tops... Shits stay on nice and tight..... If its popping off that easily I would contact whoever sold it to you.

[Ashop]

Here is what happened. As I took the metal off the top of the test cyp vial it all came off. No biggie the rubber top stayed on. However when I injected air into the vial to draw the top popped open slightly and a bit of oil came out. I quicklyyyyy closed it as it barely opened.

So after injecting I sat there looking at the vial and was concerned that it wasn't a good idea to keep my stuff in it. I decided to preload two syringes. They are basically next weeks shot. There is another syringe that is partially full and I suppose I can use that for the week after.

I preloaded the syringe and then changed the pin and put it back in it's packaging and put it away in a cool dark place.

Do you guys think it'll be ok for a week? I plan on changing the pins before I inject.

I think you will be just fine. Its only a few weeks worth.