Dosages for first Trenbolone cycle, please advise

[KimboHalfSlice]

How does the following look for a first-time cycle of Trenbolone? All of the following are to be put in a single syringe and injected once every 3 days:

hCG -- Week 1-12 -- 250iu
Sustanon -- Week 1-12 -- 250mg
Tren E -- Week 3-12 -- 150mg

Followed by:

Clomiphene 100/50/50/50
Tamoxifen 40/20/20/20

The Trenbolone dosage is to start off at 75mg and then it will be increased by 15mg with every future injection until it reaches a maximum of 150mg.

[iceman86]

stats?

[Bonaparte]

I'd just run a steady dose of Tren E from week 1, then drop it after 10 weeks.
And you don't want to load your HCG into the same syringe as the oils. Just do it separately with a slin pin (its a fragile peptide, so you want to keep it cold and alone, rather than mixing it with the oils which should be heated up prior to injection).

[KimboHalfSlice]

And you don't want to load your HCG into the same syringe as the oils. Just do it separately with a slin pin (its a fragile peptide, so you want to keep it cold and alone, rather than mixing it with the oils which should be heated up prior to injection).

It's all gonna be hot and mixed up once it enters the muscle; I don't see any harm in having it mixed for an extra 2 minutes in the syringe before it enters the muscle.

I'm gonna aim to have the syringe at about 25 degrees centigrade.

Does anyone know what a typical concentration would be for Tren E (mg per ml)?

[iceman86]

It's all gonna be hot and mixed up once it enters the muscle; I don't see any harm in having it mixed for an extra 2 minutes in the syringe before it enters the muscle.

I'm gonna aim to have the syringe at about 25 degrees centigrade.

Does anyone know what a typical concentration would be for Tren E (mg per ml)?

200mg/ml

[Bonaparte]

It's all gonna be hot and mixed up once it enters the muscle; I don't see any harm in having it mixed for an extra 2 minutes in the syringe before it enters the muscle.

I'm gonna aim to have the syringe at about 25 degrees centigrade.

Does anyone know what a typical concentration would be for Tren E (mg per ml)?

Ah, well I just steep my vials in near-boiling water while prepping for the injection. Regardless, the additional solvents and pH values may not be good for the hCG. Better safe than sorry here. Slin pins are so cheap and painless...

Tren E is normally 200mg/ml.