Did my second shoulder pin. Got some leakage. Enough to fill a dime...so probably a lot or all of it? 250mg so 1 ml. Pissed me off a lot. How do you all prevent leakage? Should I pin again tomorow to make up for it?
Printable View
Did my second shoulder pin. Got some leakage. Enough to fill a dime...so probably a lot or all of it? 250mg so 1 ml. Pissed me off a lot. How do you all prevent leakage? Should I pin again tomorow to make up for it?
I don't know a way to prevent leakage. But I did notice that if I pin after a workout, I leak a lot more than if I pin before. Just have something ready to immediately block the site.
I've heard if you do your delt, to lay your arm on a bed so that you're pinning straight down. Harder for the juice to come up. Also should remove the pin quickly rather than slowly. Juice will follow the pin. If you remove t quickly you will have a second or 2 to block the site.
I will try the bed idea. I pinned before a workout. Such a piss off. I may pull the skin and muscle a bit to the side so the needle goes in | but once its out the hole is like this \ so its harder to leak. But doing it with one hand is hardd
Inject slower. Leave pin in at least 10 second. When you pull pin out press hole with your finger. You didn't loose enough to worry about. Other body parts gently pull skin to the side while you pin. After pinning let skin go it covers the hole in the muscle. No leak
I injected suuuper slow. I always time it and it was 1 min 30 seconds for 1cc. Stated in for 10 seconds but didnt pull skin.
Wow. That is a slow pin. All most impossible to pull the skin on delt. Is your arm relaxed or bent at the elbow? Honestly the way you said your doing is perfect. Some days going to loose a little I guess.
****. Bent at the elbow but it was resting on my leg so the delts weren't activated at all. This time I did try and heat the solution up just a little tho! Next time I wont be doing that.
Just put a finger over it and apply a bit of pressure after removing the needle. This isn't rocket science.
Don't use your finger unless you're positive its clean. (common sense but you never know).
For delt, I usually put my hand under the other armpit when injecting. It gets held in place and makes for a more steady injection.
Look up z-track injections. While it may be difficult to pull the skin, it is still possible to do, even if it is only a mm it will help with leakage.
You're supposed to wash your hands before performing an injection. So that's a moot point.Quote:
Originally Posted by austinite
And your hands would literally have to be covered in MRSA puss and feces for anything to come of it (since you're covering a tiny break in the skin with positive pressure coming out of it, not jamming your finger into an open wound).
I use the little alcohol swabs. I know my finger comes in contact with it when I clean the area to be pinned and wipe after I pin. I also use the swab to put pressure on
1. inject slow
2. leave pin in for 10-20 secs
3. apply pressure to inject site immediately after removing pin.
easy as 1,2,3..
AAS are meant to be injected deep IM. Are you injecting deep enough?Quote:
Originally Posted by KidsMeal27
5/8inch on my delt. First pin was perfect. Today leakage :@
Is 5/8 ok for the delt ? I know it's to short for the ass.. I have been using 1 inch on delt.. 1 1/2 on ass .. What about for the thigh ? I haven't done my thigh
Ass is huge tho. I would guess 1 inch for ass just like quads. I pin quads with 1 inch. 5/8 for delt?
remember to relax your muscle completely. don't move, and don't even twitch. when it's soft and relaxed, there is more space for the oil to flow in between the muscle fibers, so less will squirt back out.
give up stick to orals no worries, lol try quads they're larger and can handle more volume than the delt. leave your pin in for 20 secs or so the pullout thats the rule if your in it for longer than 20 secs with no protection leakage can happen and bam next thing ya know you have a little girl! lol