tips for warming gear before injecting

**mnt51** · 05-20-2012, 07:22 PM

Looking for tips on how you all that warm your gear before injecting do it. Thanks

**t-dogg** · 05-20-2012, 07:25 PM

Take a shower and leave the gear in there as you shower. Then roll the bottle in your hands afterwards. Should be fine.

**Far from massive** · 05-20-2012, 07:27 PM

Just put it in hot water. I run hot water in a pan then place it on stove and turn burner on high just about when it starts to boil the water in the vial is about 115°f or so, then by the time I get it in the pin and in my body its just slightly above body temp.

Things to note, You can just use hot tap water it will just take a few minutes to get it up to temp. No need for a vent pin ever when heating AAS as long as there is air space to allow expansion there will never be a problem with pressure. Do NOT use a microwave oven this can destroy the hormone and is very dangerous to boot. Make sure its not too hot before injecting LOL.

Enjoy,

FFM

**AsEpSiS** · 05-20-2012, 07:51 PM

i use a blowdryer when the gear is in the syringe

**austinite** · 05-20-2012, 07:54 PM

Just run hot tap water over the loaded syringe.

**smokethedays** · 05-20-2012, 09:38 PM

Originally Posted by AsEpSiS

i use a blowdryer when the gear is in the syringe

Are you serious?!!

**Bonaparte** · 05-20-2012, 10:31 PM

Originally Posted by austinite

Just run hot tap water over the loaded syringe.

This is what I do now.
I used to heat water in a cup in the microwave, then steep the vial in the water prior to drawing. But I now see that as a hassle.

**nikepump8844** · 05-22-2012, 10:42 PM

warm the syringe with hot water in the sink, but make sure to (re)sterilize the pin following this. unlike boiled water, hot tap water can contain significant bacteria