Question about mg/ml

So I've been doing a lot of reading on this and other forums about steroids, but one thing I've not seen is an explanation of why certain steroids are the mg/ml they typically are, for example why is Test commonly 250-300 mg/ml, where Tren seems to be usually 100 mg/ml? Does this have to do with the amount that's stable in solution or is it just arbitrary? Say you want to run 600 mg test per week, with 300 mg/ml that's 2cc per week, but would it be possible (in theory) to concentrate test at 600 or even 1200 mg/ml and cut down on the number of injections?

The only thing I can think of, assuming you could get that concentration to be stable, is that it would be absorbed too quickly because there'd be so much Test in a single cc, is that the case, or would the body still utilize it at the same rate and you'd just be injecting weekly or bi-weekly instead of 2x per week?

Welcome to the forum Panzer. Well you're right about why some compounds are different concentrations per ml. There is a limit to how much can be held in solution. Of course this can be different depending on what chemicals are used to dissolve the hormone. Another reason is pip (post injection pain). Higher concentrations tend to cause more pip. Sometimes a lot more. So rather than have the pip you lower the dose per ml and do multiple injections per week. There's other more complicated reasons for the dosages being what they are typically mg/ml but these are two of the main reasons. Hope this helps.

He is right some of the more potent stuff hurts like hell.

You can get solutions to hold at very high concentrations for example test e at 6/700 but the amount of different chemicals you have to use combined with a extremely high benzyl alcohol content it will hurt like wildfire.
You can always pressure cook it at 15psi after brewing to help with pip but it's not favourable to brew using such high doses.

I have before brewed test e and tren e blend at 600mg/ml so 300mg test e and 300mg tren e per ml and used 2% benzyl alcohol 20% benzyl benzoate and rest ethyl oleate instead of oil and it held pain free.
But that was years ago and nowadays I try to get it simple less chemicals in the mix for a purer mix

Quote:

---

Originally Posted by panntastic

You can get solutions to hold at very high concentrations for example test e at 6/700 but the amount of different chemicals you have to use combined with a extremely high benzyl alcohol content it will hurt like wildfire.
You can always pressure cook it at 15psi after brewing to help with pip but it's not favourable to brew using such high doses.

I have before brewed test e and tren e blend at 600mg/ml so 300mg test e and 300mg tren e per ml and used 2% benzyl alcohol 20% benzyl benzoate and rest ethyl oleate instead of oil and it held pain free.
But that was years ago and nowadays I try to get it simple less chemicals in the mix for a purer mix

---

You must be up with that new little angel lol.

Quote:

---

Originally Posted by Lunk1

You must be up with that new little angel lol.

---

Bringing her home today :)

Quote:

---

Originally Posted by panntastic

Bringing her home today :)

---

Good deal...make sure to get her on a high protein diet right away lol. With her size there is some real potentiol there ;)

Yeah, I'd love to see Primo @ 300+ per ML, not gonna happen.