
Originally Posted by
Charles pipes
I have a bunch of testosterone undecanoate pills. 100 pills of 40 mg each. It takes 4 per day, or 160 mg testosterone total because it is very poorly absorbed. However, if I injected the undecanoate I could greatly increase the length of time and greatly reduce the cost. IF I go for say 150 mg/ week for starters on average, roughly 20 mg per day, I am getting 8 times as much testosterone. The pills are softgels with oil in them. I dunno if they are castor oil or not.
It is a particularly interesting approach because I can get test U pills prescribed, so I don't have to take risks with UG gear. You think it is practical? Probably a good idea to avoid the stuff in castor oil I reckon, as the grade of castor oil used in the pills might have higher ricin content than that used in injectables (which it is also used in mind you). I have yet to look up the exact ingredients for the pills, but the mfgr probably says them somewhere. Another issue is that it would probably not be sterile, so a sterilizing filtration step with a 0.22 micron filter would be a good idea. Perhaps a syringe filter (a little filter that goes in between the needle and the syringe). It may even be possible to simply put the syringe filter on, suck the oil+test out of the softgel, then remove the syringe filter+needle, replace with a fresh needle, and inject. Boom. Depends if there are any ingredients in the oil that may be troublesome for injection.
What do you think? This could be a good method for people to obtain test as you can get your test prescribed relatively easily, or those who require it for TRT can get it prescribed, inject 1/8nth for their own needs, then sell the remaining 7/8 to their bros. Boom, pharm grade test for all.