First Pin with TEST E

[biggjd69]

This will be my first injection and I have 25g x 5/8 to pin in my Delts or Glutes. I see more here have 25g x 1. Is 5/8 not good? Thanks

[Bio-Active]

This will be my first injection and I have 25g x 5/8 to pin in my Delts or Glutes. I see more here have 25g x 1. Is 5/8 not good? Thanks

5/8 probably isn't deep enough for glutes. I am pretty lean and use a 1 inch

[stpete]

I prefer 1-1.5 as well.

[songdog]

Go deeper Bro!

[t-dogg]

Go deeper Bro!

Lmao i saw this post as i open this section up on my phone. Didnt know what to think.

[MuscleInk]

I never use anything less than 1inch. On occasion I've used 1 1/2 on glutes but 1 inch is sufficient unless you are portly.....and then perhaps you shouldn't be using AASs if you are too heavy.

[Sick_beard]

I never use anything less than 1inch. On occasion I've used 1 1/2 on glutes but 1 inch is sufficient unless you are portly.....and then perhaps you shouldn't be using AASs if you are too heavy.

I have 27g 1/2 inch... would these work on delts, biceps and pecs?

[warmouth]

I have 27g 1/2 inch... would these work on delts, biceps and pecs?

Should be fine on pecs and bis. Wouldnt try delts. 5/8 can be used on them if you are lean, but pecs and bis for sure. 27 gauge, I am not sure how your gear would flow through.

[Sick_beard]

Should be fine on pecs and bis. Wouldnt try delts. 5/8 can be used on them if you are lean, but pecs and bis for sure. 27 gauge, I am not sure how your gear would flow through.

I only have 1/2 inch and 1 inch. Which would you use for delts? I'm pretty lean btw

[warmouth]

1 inch for delts.

[losieloos]

I like 23g 1 1/2

[Soar]

Just make sure you don't forget to change from the drawing needle to the injection needle.
Attachment 132113

[diabolicsoul]

Should be fine on pecs and bis. Wouldnt try delts. 5/8 can be used on them if you are lean, but pecs and bis for sure. 27 gauge, I am not sure how your gear would flow through.

That. I found it nearly impossible to draw with a 25 gauge, and have to press fairly hard on a 23 gauge. <----- that's my experience.