It takes me 5 minutes to get just 1cc into syringe. I pullback amount I want in air into bottle I hold upright and pullback it is slowwwwww. Am I doing something wrong. Angle? I know pins are small as it is 25
Printable View
It takes me 5 minutes to get just 1cc into syringe. I pullback amount I want in air into bottle I hold upright and pullback it is slowwwwww. Am I doing something wrong. Angle? I know pins are small as it is 25
You've just answered the question buddy your pins are far too small get some 18's ;)Quote:
Originally Posted by keano
Fill the syringe full of air and pump that into the vial that will helpQuote:
Originally Posted by keano
Also warm the vial in water to make the oil thinner
Agreed on the needle size. I always always warmed my bottle up it was easier to pin and I had less PIP
Done deal thank you.
You are switching out the pin before you inject right?Quote:
Originally Posted by keano
Nah, I like mine blunt and hurty! :)Quote:
Originally Posted by jim230027
Yea I do.Quote:
You are switching out the pin before you inject right?
Yea if I don't gotta use a hammer to get it in, it's too sharp!Quote:
Originally Posted by krugerr
Recall somebody mentioning and auger drill and filling the hole?Quote:
Originally Posted by >Good Luck<
Lol