-
05-19-2013, 12:21 AM #1Associate Member
- Join Date
- Dec 2011
- Posts
- 171
Is 1 Inch needle too long for deltoid?
You know I have been using 1 inch for deltoids in the past, but that just seems too long. I am wondering if I should use half inch or 3/4 inch pin. I just think 1 inch would like hit the bone. I don't think I ever have, but just seems long. Because the deltoid muscle is not near as big as your glute.
What do you guys think?
-
05-19-2013, 12:22 AM #2Banned
- Join Date
- Apr 2013
- Posts
- 48
no..
-
05-19-2013, 12:25 AM #3Associate Member
- Join Date
- Dec 2011
- Posts
- 171
-
05-19-2013, 12:26 AM #4Banned
- Join Date
- Apr 2013
- Posts
- 48
well then don't stick it in all the way.
As long as it makes it under the skin, it's fine. Pip might make you cry if it's too shallow lawl
-
05-19-2013, 12:28 AM #5Associate Member
- Join Date
- Dec 2011
- Posts
- 171
-
05-19-2013, 12:30 AM #6Banned
- Join Date
- Apr 2013
- Posts
- 48
PIP=post injection pain.
If you inject too shallow, you will feel it the day after you pin haha. You're still getting the steroids though. Just try different depths. For me 1 inch is fine for delts.
-
05-19-2013, 12:36 AM #7Associate Member
- Join Date
- Dec 2011
- Posts
- 171
What happens if the juice does not go into the muscle and it goes somewhere else. I highly doubt that will happen. As I imagine your muscle are like big and round. So it would be hard to miss it or go through it all the way or whatever... But what would happen?
I think I am going to start injecting in other areas. Because I have had two people tell me they noticed me limp every once and awhile. And I been injecting in my right glute two times a week. I cannot figure out what they are talking about because I feel fine. My right glute is a little bit sore, nothing major of course. But when two people ask you what's wrong with your leg or if your in pain it makes you wonder...
I just got done writing about this at Injecting in glute (and limp few days after?)
-
1" is fine for delts...
I find if you don't stick a needle in the whole way, once you have aspirated the chances of that needle being in the same spot is rather low, I did come up with something to prevent this if you can't go out and get smaller pins, what I used to do with my 1.5 for my thighs is I would take an old needle cap, I would then cut off the desired ammount off the top of the cap leaving the ammount of needle you wish to pin with exposed, you can then push all the way to the skin with out the risk of pulling pushing the needle in and out while injecting.
-
05-19-2013, 01:57 AM #9
-
05-19-2013, 01:58 AM #10
use a 5/8 is you're hitting bone. I wonder if you're too skinny and should not be injecting anything.
~ PLEASE DO NOT ASK FOR SOURCE CHECKS ~
"It's human nature in a 'more is better' society full of a younger generation that expects instant gratification, then complain when they don't get it. The problem will get far worse before it gets better". ~ kelkel
-
05-19-2013, 03:03 AM #11
I stick that sucka with a 23g, 1-1/2 goes tru like butter
-
-
05-19-2013, 09:03 AM #13
-
05-19-2013, 09:07 AM #14
I do 1 for delts
-
05-19-2013, 09:27 AM #15
1s for delts are perfect.
-
05-19-2013, 09:38 AM #16
1" 25g for me
-
05-19-2013, 10:03 AM #17
1 inch for me in the delts. Although a 1.5 works to.
-
05-19-2013, 01:58 PM #18
1 inch always works for delts and tri's.
-
05-19-2013, 02:14 PM #19Associate Member
- Join Date
- Dec 2011
- Posts
- 171
-
05-19-2013, 02:14 PM #20
3/4 Pin
-
05-19-2013, 04:55 PM #21
1 inch 23g is my choice for delts. Go smaller if needed, then when you put some meat on them bones move back up to 1". I do my hcg in my delts and test e in my glutes, using 1.5 inch 23g.
-
05-19-2013, 06:49 PM #22new member
- Join Date
- Jan 2013
- Posts
- 578
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Next cycle... Just...
Yesterday, 08:17 PM in ANABOLIC STEROIDS - QUESTIONS & ANSWERS